Ski-Doo Snowmobiles Forum banner
wiring diagram
1-10 of 10 Results
  1. REV Chassis - Performance and Trail Models
    I just purchased a 2008 MXZ X 600 HO and the hand warmers do not work. I took it to a dealer and he said the previous owner must have upgraded the instrument cluster with premium gauges which do not support the hand warmers. He also hooked up the sled to his computer and the hand warmers worked...
  2. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    I just purchased this 2008 Ski Doo MXZ x 600 HO and the hand warmers do not work. I took it to a dealer and he tested it and said that the previous owner had upgraded the instrument cluster with premium gauges which did not support the hand warmers. When he ran the hand warmers through his...
  3. Skandic / Expedition
    I need to sort out the wiring connectors at the hood hindge for a 2004 ski doo skandic 550 fan (no electric start) PO pulled the pins out of the block, thanks
  4. REV Chassis - Performance and Trail Models
    I recently purchased an 06 mxz 500ss for pretty cheap. That being said there are a couple of issues that i've noticed about it right off the bat. I was also told that the top end had just been replaced because the motor "blew". Here are the issues... Carb boot is ripped on PTO side (I just put...
  5. Vintage Ski Doo's
    Hey guys, I'm just getting back to our Elan's no spark issue from 2 winters ago. I believe the condenser is bad, I can wiggle the solder joint and it's very sloppy and appears aftermarket. I've cleaned the points and retested with no luck. While I have the flywheel off I'd like to test the...
  6. MXZ / Legend / Summit / Grand Touring / Formula
    I picked up a 1994 ski doo formula 583 stx rave, and its been sitting for 3 years. The gas is varnished but I still tried to start it. When it didnt start I pulled the plugs and poured some gas in the cylinders. I checked the plugs and they were getting spark but I had the key off. So I looked...
  7. MXZ / Legend / Summit / Grand Touring / Formula
    hand warmers quit working last year, but thumb warmer still works. i put on brand new RSI warmers today thinking that would fix the problem. Ive been tracing and testing wires all day and dont have any power to the hand warmer switch. the wiring for the hand warmers vs the thumb warmer is set up...
  8. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 2001 mxz 800, and need help with the wiring. Does anybody know what color wires go to the red dash key light that is between tach and speedo. It is the bottom of 4 small dash lights. Or does anyone have a wiring diagram they could send or photos.
  9. MXZ / Legend / Summit / Grand Touring / Formula
    I want to add a battery and a regulator / rectifier to my 1999 MXZ 670HO. I am new to this but I have been reading stuff on this site for a little while. Just never got a solid answer for my questions. I have attached a diagram of my thoughts so you can view and read what I am thinking. There...
  10. MXZX Race Sleds
    I am trying to install some hot grips and a thumb warmer along with a kill switch. The wires on the all the controls were cut (not by me) and there are no connectors to plug into the factory steering harness. Does anyone have a diagram with the pin location and wire colors or a wiring...
1-10 of 10 Results
Top