I have a 2016 Ski Doo Renegade Adrenaline 800 with water pump issues I had the sled out last year and it overheated on me and would not cool down unless I let let sled sit for hours. After this the sled would not run. I replaced the water pump and it ran fine for about 2 hours and then the sled...

Hi Folks, I took my sled (2015 renegade 600 etec) for a ride after sitting in the cold (-25C to -30C for a week), and noticed it seemed to be running warm for the conditions. Then I smelled antifreeze. Sure enough I had a leak and the reservoir was dry. Got the sled home and as near as I can...

Hello, Newbie from the UP! I have a 1999 MXZ 600 and I recently have had some overheating issues. Long story short, I have found the problem and the plastic gear on the water pump shaft is stripped. I have a new shaft assembly coming and I'm hoping to to get everything back together this...

Please accept my apologies regarding the length of this post. In mid-December I bought an MXZ X 850 from Andre & Son Powersports in Montrose, PA. When running correctly, nothing I've ever ridden comes close to the fun I had on this sled. But on February 4th, it broke down, leaking coolant and...

WE WILL BUY YOUR USED WATER/OIL PUMP SHAFTS. LET US KNOW WHAT YOU HAVE BY SHOOTING US AN EMAIL WITH ATTACHED PICTURES. THANKS, MCB [email protected] (810) 395-7162

We will buy your used, but good condition water/oil pump shaft. Let us know what you have by shooting us an email, and pictures attatched. Thanks, MCB [email protected] (810) 395-7162

Anyone experience a cracked water pump housing? Is it possible to replace it without pulling the engine?

hey guys, so last time i ran my sled, the temp gauge says it was warmed up, and was pissing out coolant and a steady rate the the engin bay, tore the sled apart and the gasket on the water pump and gone, anyone every experiance this before? its like when pressure in the system builds up it...

I put my new crank in, and forgot to run the wires through the hole, can I cut them and re-solder them in order to run them through the hole? Or I would need to split the case again, I don't want to do that, its a big job. The wires I would need to cut are the 3 voltage regulator wires. Also my...

Got the discolored oil in the reservoir so I'm going to replace the oil/water pump shaft. For those who have done it: Any pointers or things to watch for? Can it be done in the chassis or must it be done with motor out on the bench?

2009 Summit Hillclimb, RK Tek 860. Water pump shaft Snapped in half.. What would cause this? Everything in motor is new, well besides the water pump which I should have done while I did everything else, Hind sight, lol..