Ski-Doo Snowmobiles Forum banner
tuning
1-13 of 13 Results
  1. Sled Parts For Sale or Trade
    Item: Motion Pro Shop Carb Tuner #P511 w/Refill Category: Sled Year: N/A Location: Florida Price: $60 + Shipping SOLD! Motion Pro Shop Carb Tuner #P511 w/Refill - Vintage Synchronizer. Original owner and used to tune Motorcycles, Snowmobiles and works very well by a quality manufacturer. If...
  2. MXZ / Legend / Summit / Grand Touring / Formula
    I've got a 2001 Grand Touring 500F - Bought it at an auction for 400$ and it had been sitting in a barn for over four years. I've got nearly everything in the fuel system replaced/cleaned including the carbs - I just can't seem to find the settings for these carbs anywhere online and my...
  3. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Hi, this is my first post so bare with me. I am looking for some advice on tuning my 2008 ski-doo mxz 600HO SDI, but first id like to give a little back history on myself. I am relatively new to snowmobiles but have ridden dirt bikes and quads my entire life. A few years back i purchased a...
  4. Mach Z / Mach 1 / Formula III Triples
    I bought a basket case F3 600 this fall for $200. The sled had been a good runner but had been partially torn down to make a race sled then sat under a cover for a year or two. Long story short, I have a small budget but the sled is running and running well. I have to service both clutches...
  5. REV Chassis - Performance and Trail Models
    Ok guys to start out I know how to wrench and do anything but when it comes to these "fine art" areas I am pretty weak. So I recently traded my Yamaha r1 for a "2005 rev 440 with a (what he told me) factory mod 800 motor in it. details about the sled flat slide carbs non heated (so they are...
  6. MXZ / Legend / Summit / Grand Touring / Formula
    Hi As many other people on here have written about, I too have just cleaned my RAVE valves ('97 583), for the first time and now notice them clicking/ticking while at idle as well as the standard engine exhaust noise seems to be at a different pitch at around 6000 rmp. I have read pretty much...
  7. Vintage Ski Doo's
    hello, i am new on dootalk, and i have a 503 Rotax, which i am planning on building a tuned pipe for. i have the software to build it, except i don't have the port timing measurements, and i have the engine in pieces so i cant measure it myself. i was wondering if anyone could help with that? it...
  8. MXZ / Legend / Summit / Grand Touring / Formula
    Hello everyone... I have a 96 670 MXZ I have been working on as a little spare time project, I bought it blown up with an Aerodyne tubo kit on it. I am wondering if there is any one out there that may have or had one like this before that might be able to give me some advice on some setup and...
  9. MXZ / Legend / Summit / Grand Touring / Formula
    Hey all! i was riding last weekend and noticed that when i would slow down i could hear what sounded like a ratcheting sound coming from right under where the track comes out of the sled(so it sounded like). i thought it might be a bad bearing in a bogie wheel? but i could feel it throughout the...
  10. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 99 ski doo mxz 600 that had a bad crank seal. the motor ran fine just over heated. so i pulled the motor and bought a 02 ski doo mxz 500 motor from a burnt sled and put that in. It runs but it will only run with the choke on a little. otherwise it dies. so i put different carbs on and...
  11. Sledding - General Discussion
    i recently bought a complete electrical system from a 02 mxz 800 with rer (mainly because my 600 doesnt have rer) and i need to get the mpem tuned. i was wondering if there would be some contact info on a person who can tune mpems
  12. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Okey, I am a fairly new member and first time poster. Hoping I am doing this right. So I bought an mxz xrs 800 2010 earlier this winter. The sled runs fine but I would like to see if someone has some tips on basic tuning of the clutches. What springs and weight setup that would be good? I would...
  13. REV Chassis - Performance and Trail Models
    Jet Kits for MXZ 800 HO Power T.E.K. PRICE $39.95 USD Shipped Jet Kits for 03-07 SKIDOO Rev MXZ 800 HO and MXZ 800 HO Power T.E.K. machines. These Jet kits will stop the awful back firing, high idles, mid range lean conditions causing detonation (rattling the y-pipe bolts out) , and leaning...
1-13 of 13 Results
Top