Ski-Doo Snowmobiles Forum banner
trouble
1-4 of 4 Results
  1. MXZX Race Sleds
    Hey All, Heres the long story made short- Bought a 2014 600 RS with the hot start hooked up, worked fine. Brought it home and disconnected pin 10 ecm. Sled worked fine. Synced the carbs, plugged pin 10 back in, reset TPS, unplugged pin 10 again and worked fine. Out playing a week later -...
  2. 900 ACE 4-Stroke Models
    Been having issues with my battery draining after a recharge for a while now. Inspected the wiring harness, tried different batteries, used the multimeter to diagnose different uses or the power. No Luck! All I have to my knowledge is the brass "bolt" grounding lug on the foot well at the left...
  3. REV-XP / XM Chassis - Mountain Sleds
    Hey guys I'm new to the forums so I may need to be referred to another category but anyways , I own a 2010 mxz 800 Xrs and I'm 6'1 an the stock bars and 5.1 riser wasn't enough so I went and purchased a 7inch rsi riser and a set of rsi backcountry bend bars I believe their 3inch rise and then I...
  4. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    I just had oil and chaincase service. Rode the sled over 100 miles...used rev 4 times and was fine. Now after a few days of sitting shifting R lever, light comes on and beeper beeps but as soon as I hit the gas a high-speed grinding happens as if the gear is just touching and not engaging. Shift...
1-4 of 4 Results
Top