Ski-Doo Snowmobiles Forum banner
throttle
1-20 of 21 Results
  1. REV-XP / XM Chassis - Mountain Sleds
    I have a 2014 Summit SP 800 R and am trying to replace the throttle cable. The maintenance manual doesn’t give much information on how to access the throttle actuator where the cable mounts on the engine. It is buried enough under the actuator bracket for it not to be a simple swap and swap out...
  2. REV-GEN 4: MXZ Perf. Trail 129/ Renegade 137
    Hey guys I've got a 2017 Renegade 850 X that suddenly started acting up over the weekend. It starts and runs perfect, and has usual power, IF I dont go past about 1/8 to 1/4 throttle. Beyond that it makes a slightly louder noise and loses power. If I dont push it past 1/4 throtlle I can still...
  3. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    I just purchased a 2010 MXZ 1200 Adrenaline with 500 miles on it and after riding about 25 miles, there is a sputtering and loss of throttle. It will maintain speed but it will not accelerate. Every time it happened I was light on the throttle riding over bumps (not sure if that is a trigger...
  4. Vintage Ski Doo's
    Hey everyone, hoping I can get some tips and advice on replacing my throttle cables in my 1987 Ski Doo Tundra 250 Single. I am new to the snowmobile world. I have ordered a replacement throttle kit but having never done any of this before I am looking for any advice I can get. Is it hard to...
  5. MXZX Race Sleds
    looking to change my rs800r into a 2016+ rs and keep the 600 engine. Question i have : has anyone raised a handlebar on a 16-17 or a 2018 rs ? what you did with the throttle cable ? looks like there is not much stuff out there to fit raised handlebars asking this because i will ride freestyle...
  6. MXZ / Legend / Summit / Grand Touring / Formula
    morning all Anyone know the resistance I should measure for a heated throttle lever? Switch good. Power on both sides but no heat. Any help much appreciated. M
  7. REV Chassis - Performance and Trail Models
    So I broke the thumb throttle at the pivot on my 07 renegade. I don't know if anyone else has this problem, but my thumb literally goes completely numb at the point where it contacts the lever. We do trail riding (200 mis. minimum a day) in Canada and I find it doesn't matter if I have the...
  8. MXZ / Legend / Summit / Grand Touring / Formula
    Hey guys, I have a 2001 MXZ 700, Planning on putting a 7 inch riser on the handlebars. Was wondering if it is better to get a while new throttle cable (like so http://www.ebay.com/itm/151176472259?_trksid=p2060778.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT) or if it is better to just get a...
  9. REV-XP / XM Chassis - Mountain Sleds
    Hey guys I'm new to the forums so I may need to be referred to another category but anyways , I own a 2010 mxz 800 Xrs and I'm 6'1 an the stock bars and 5.1 riser wasn't enough so I went and purchased a 7inch rsi riser and a set of rsi backcountry bend bars I believe their 3inch rise and then I...
  10. REV Chassis - Performance and Trail Models
    Hey guys, Noob here. This may be a dumb question but I cannot figure it out. I have searched and searched and cannot find the answer to this question. On my 05 600 SDI I need to remove my flipper from the kill switch because my thumb warmer burnt out. I have a spare flipper but I cannot figure...
  11. REV-XP / XM Chassis - Mountain Sleds
    Hey guys awesome day today in the Sea to sky corridor. Quick question, i had Rpm problems for awhile miy 2012 free ride (Etec) wouldn't idle below 3900 rpm. always wanted to engage the clutch. and keep rolling. I stopped shut'er down and then it wouldn't go above 1200 rpm even with full...
  12. MXZ / Legend / Summit / Grand Touring / Formula
    Does anyone know if there is a bit longer throttle cable I can use to add a 6" riser on an 01 mxz600? The 01 has the rack type carbs. There must be a longer cable from another sled that can be used. I don't want to use an extender or wait for a custom made cable. Thanks
  13. MXZ / Legend / Summit / Grand Touring / Formula
    I recently broke the throttle lever on my sled and i was looking around for a skidoo one, but all the ones i found were pretty pricy. I found this one for a Sno Pro, and was wondering if anyone of you guys knew if it would fit on my 2002 Skidoo MXZ. The part number for the lever is 0609-481. Any...
  14. Sledding - General Discussion
    i was wondering if a iqr throttle block would work on my 04 mxzx 600 because i would like to have aluminum throttle block and a push button kill switch
  15. REV-XP / XM Chassis - Mountain Sleds
    When I snowchecked my summit this spring, I noticed that Ski-Doo went minimal on the handlebars. Good deal, but they still have the big bulky killswitch. Has anyone changed out the stock throttle block to a 2 piece and momentary switch? I remember these from my racing days. I am not...
  16. REV Chassis - Mountain Sleds
    I have been hunting an issue on my machine for a couple rides now. I have a 2007 800Ho Ptek. Earlier this winter I changed out my rack carbs with another much less used set from a friend. I called the dealer today and asked about how to identify the proper position for the sensor. When i pulled...
  17. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I have a 2012 renegade 800 etec, my brother took it riding and was riding some drifts, and throttle stuck half way open on him. I started it up a couple days later and it wouldnt rev, at all. Every time i touched the throttle it would bog down like it was running on one cylinder, then when "warm...
  18. Mini Z/ Mini REV
    I have an issue with the 120 cc dying at idle unless the throttle is held lightly to keep pivot hinge closed. I think this is the safety feature for the throttle. I see a little button that comes into play here too. I am not clear but my question is does the whole throttle assy. need replaced...
  19. MXZ / Legend / Summit / Grand Touring / Formula
    HELP! I have a 2000 mxz 600 and I'm having a major bogging issue at about 3/4 throttle. rips and tears if the throttles anywhere before that, but once I get past 3/4 it boggs right down and slows sled down quick until I back it off to about half again, then she snaps. Fresh rebuild this year...
  20. Race Sled Classifieds
    I need a throttle block or complete throttle set up. I can not get old throttle over the bars I put on my rev. Anyone have anything to offer?
1-20 of 21 Results
Top