Search Results for ‘shock’

My 1997 Skandic widetrack shock needs to be replaced. I am able to find the coil over spring but not the shock it self. Looking for a 1997 front suspension shock Part Number M23017. Does anyone know where I might find one? Or other possible work arounds/fits?

Hey Guys, Was wondering if anyone knew the specs for the Front Sock absorbers on my 98 formula 3 600 Lt. I've looked around and haven't been able to find any charts with center-to-center distance, stroke, etc... I'd like to replace them since the stock ones are non-rebuildable, but I don't know...

Rear Air Shock and complete compressor / manifold setup removed from a 2021 Renegade Enduro with 495 miles. Like new condition. $450 shipped to lower 48.

Raptor shocks has a listing for a shock set that fits 2013-2020 G4/XM skids. Does that mean that I can use a stock factory take-off shock from those years on my 2013? If so anyone doing an upgrade I am looking for the rear (not the coil over) shock. If not can the 2013 factory shocks part number...

Just thought I would share this nice breakdown/overview I came across about suspension theory. This document is speaking about mountain bike suspension, but almost all of it applies to any kind of vehicle. For those who would like to understand a little more about how shocks and springs work...

I picked up a set of front and rear arms off of a 2011 XP summit to delete the T-Motion on my 15 FR 154. Only issue is, the throttle rods are a different length when comparing the two. Has anyone done this swap succesfully? Are the rear shock lengths the same from a 10-12 summit to a XM? Any...

Does anyone know the center to center distance of the new KYB shocks in the 2022 accessory catalog that fit the RASX front end 860202466. Is it same as X package? Or longer like the XRS?

I recently purchased an older (2005) MXZ 600 HO SDI with about 5400 miles. I did a investigation and repair day yesterday, and removed one of the front shocks fully expecting to find it had no dampening and little spring due to age. Its about an hour drive to Dennis Kirk, so I was fully...

I have installed the s36 RAS2 front end on my 2008 renegade, but I no longer live up north where the snow if deep and fluffy, and trees everywhere. I'm looking at widening my front end again for better stability on trails and riding across the concrete hard, windswept snow on the prairies. I'd...

Hey everyone. I've started to dabble a bit into rebuilding my own shocks (oil/ nitrogen) and things went well last year on my 2006 MXZ but this year I've been having some issues. The current sled is a 2015 Renegade adrenaline 800 that has front rebuild able shocks and junk rear shocks. After...

Can anyone confirm that the pro 40 front shocks will indeed work on the gen 4 summit? No doubt they will have to be of correct length and I would need the bushings for mounting, but I want to make sure the resi’s will not conflict with the panels! Any info is appreciated!

I have a 2019 Summit SP 146 and was wondering if the KYB pro 40 rear skid shocks from my xp 600rs will fit the skid of the summit.. sounds funny but they seem to measure up the same length! if anyone has any info on this feel free to chime in before I go through the hassle of physically trying...

How hard is it to change out the rear shock? How many hours are involved? Any special tools required. I bought this sled used and noticed the rear shock adjuster knob is broke off. ugh. Thanks in advance.

I have an 04 GSX 500ss Sport , SC3 Rear suspension with 7k miles. Center shock is junk , rear shock is almost junk but still working. Both shocks show no sign of gas pressure. Does anyone know if these shocks were gas from the factory. They are Center #503190350 (replacement # is now 503190026)...

So I'm stumped... Not hard to do haha, but still... I have slowly been up grading my rear SC10-3 skid on my 2004 500ss Adrenaline. Recently, I found a rear clicker off an 2003 440X (503189974) to replace an HPG(?) rear shock off a 2003 Blair Morgan special edition (503190446). Before the sled...

I am having a difficult time finding a front suspension coil spring for my now broken sled. I was told by a local Skidoo dealer that the springs are discontinued (?). Surely there has to be something that will fit it. Any help is appreciated.

Just bought a 2016 gade sport carb model and was looking at getting after market suspension all around. Look around online and cant really find a good set to replace the rear shocks with. for the front I was looking at fox float 3 evols. Anybody have any suggestions I do a lot of lake and trail...

The center skid shock is blown on a 2010 ski doo summit, I am not currently around the sled so I don't know the dimensions of the shock. Would anyone happen to know? Unfortunately I haven't been able to find any info about shock dimensions online. Just one of the many exciting steps to get...

I purchased a new rear Fox shock for my sled. The shock body hits on the bar just below the shock. Any suggestions to fix this problem?

I'm putting two new front shocks on my 96' skandic, they are off a 98' formula and are kimpex gas. They are about 1/2 an inch longer and I got the right one on but the sled seems hard to turn with them on and I'm not sure why.