Ski-Doo Snowmobiles Forum banner
seal
1-10 of 10 Results
  1. MXZ / Legend / Summit / Grand Touring / Formula
    Need help diagnosing a problem with my 1996 Ski-doo Grand Touring 670SE. The oil in the reservoir appears to be draining into the crank case when the sled sits over the summer. Looking for tips on diagnosing where the problem is. From what I understand it could be an inner crank seal problem...
  2. REV Chassis - Performance and Trail Models
    With the help from a few posts on this forum and a few other topics on other forums I was able to replace my PTO seal without pulling the whole motor and splitting the cases. In some of the posts I read I felt that some information was missing so I thought I would make my own post to help out...
  3. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    Just got off the phone with Fort Kent Power sports and got the revised seal number. I've lost two seal so far. Hopefully this does the trick. Part# 420431402. Hope the helps!
  4. Mach Z / Mach 1 / Formula III Triples
    hey guys, so after i replaced my new track, put everything back together took it out for s ride. Got back and checked the oil level and it had all leaked out. is there a o-ring that i can put behind the bottom gear to stop it from leaking? cant find the seal and i dont think it is bad, any help...
  5. MXZ / Legend / Summit / Grand Touring / Formula
    Hey guys, I have a couple of questions. I have a 1992 Ski Doo Formula Plus 580. It does not have reverse. I recently replaced my track and suspension to the SC-10 model. While I had the chain case apart, I noticed I need to replace the seals in the chain case. I need the part number for the...
  6. MXZ / Legend / Summit / Grand Touring / Formula
    hi, so can you do a leak down test on just that center cavity in the crank case where all the oil is for the water pump? i gotta check to see if my inner crank seals are bad. i have the engine completely disassembled.
  7. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Is there any place better priced than Gear heads. Looking for end seals, ring, isoflex, Graisse, radiator hose 509000673 and maybe a cylinder. Cylinder probly sending to Millenium $200 to repair. 2010 600 etec 1600 miles. Are there any better seals out there to purchase? Thank you Dan
  8. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Driving this weekend and heard a tin kind of sound. Not a grinding but like a grazing sound. (hard to explain) sounded like it was coming from my primary clutch. Did not sound harmful at all. Continued to ride and felt like i blew a belt. I pulled over and shut the engine off immediatly. Belt...
  9. REV Chassis - Performance and Trail Models
    2007 blizzard 800 need to replace pto crank seal but can not get cover plate off"! Loctite? Do I need heat? Any suggestion? It is a 4mm hex head correct?
  10. REV Chassis - Performance and Trail Models
    So I help my freind yesterday remove and clean his clutches on his 2004 500SS. The sled has about 1500 mi. When I pulled the primary clutch there was a lot of grease behind it on the PTO seal. It looked like dirty isoflex. I wiped it up and the seal looks great. Any ideas why the grease is...
1-10 of 10 Results
Top