Ski-Doo Snowmobiles Forum banner
rpm
1-19 of 38 Results
  1. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I've got a 2017 600 Renegade with less than 1000 miles on it. I think it's been doing this since new. Problem 1- It will only top out at 7800 RPM. And that's on flat smooth lake/trail with hardly any loose snow. I might get 85 MPH or a little higher on GPS. Seems low top speed and RPM...
  2. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    I started up my 2009 mxz renegade 1200 this after noon to get one last little ride in and the rpms were going up and down, I didn’t think much of it at first but then it got worse. Any ideas on why the rpms would fluctuate while idleing. The sled is bone stock and only has 3750 miles on it.
  3. MXZ / Legend / Summit / Grand Touring / Formula
    I bought a 2001 MXZ off kijiji last year. I didn't find out until later he had done an engine swap on it. I found a whack of problems from the carb drain coming out and the clutch coming off as well as others very soon after it was in my possession. I think I got most of his mistakes figured...
  4. REV Chassis - Performance and Trail Models
    So my tach isn't reading right, when I use full throttle it was only reading 6k, after an hour it did reach up to 6300. The next day it only read 5k then shut it down and only read 4K but still pulls hard and revving high. Any ideas?
  5. REV Chassis - Performance and Trail Models
    Hello, In need of some assistance, with my 2003 800 BM. Issue #1; I believe the sled is running lean on oil. I have gone through nearly a tank of fuel and only a 1/4 tank of oil. What should the sled be going through. I'm not sure of the proper mixture. Issue #2; The sled maxes out at 7500...
  6. MXZX Race Sleds
    I bought a 2008 ski doo 600rs and the tach only works sometimes it sweeps at start up like it should but doesn't read. If you hook up another gauge cluster it works fine. I want to change one into it so I can hook up a fuel gauge to because my trail size tank has wires coming out of it to hook...
  7. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Hey, Just picked up a 2012 bcx 600 etec and I am having issues with the clutch. It will engage about 3200 and start pulling. The rpms increase from 3200 to almost 5000 and it doesnt go any faster. Stays about 20 km/h. I watched the clutching and after it engages the primary stays where its at...
  8. REV Chassis - Performance and Trail Models
    Hello fellow sledders. I was out today in my 04 GSX 500ss playing in fresh powder and doing some carving. I was having some fun when i noticed my sled was going all the way up to 9000RPM with only a little bit of throttle. it sounded horrible and I wasn't getting all my potential power. How can...
  9. MXZX Race Sleds
    Fresh top end, was running great, and now it will hit about 7000 and that's it, not as snappy as it should be, sputters off the line. When boon docking it bogs down to about 6000 and then takes awhile to get going again. I checked rave valve and plugs. Carbs maybe?
  10. 900 ACE 4-Stroke Models
    An easy DIY mod that helped me get an 800 rpm increase in my ACE. Hopefully someone else will find it useful: http://www.dootalk.com/forums/topic/1196002-30-clutch-kit-increase-600-900-ace-rpm/#entry14569706
  11. Sled Parts For Sale or Trade
    Item: RPM Carbon Fiber Skidplate XM/XS Category: Sled Year: N/A Location: Edson, Alberta Price: 620 CAD Up for sale are 2 RPM carbon fiber skidplates. These are the strongest and tighest fiting skidplates money can buy. Nothing will penetrate through these. I have ran these on my last 3 sleds...
  12. Skandic / Expedition
    My 2012 Expedition 600 etec looses RPMs when cruising and the max RPMs I can reach is approxinately 7000 RPM. When cruising, the sled begins to bog and drops about 500 RPM and sticks at ~6000RPM. When squeezing the throttle, RPMs stick at about 6500 but in time I can manage to get it up to...
  13. REV Chassis - Performance and Trail Models
    Fresh engine, from top to bottom. I have 1,570 miles on the new engine and it's ran great so far, until now. I think I'm having an issue with the Primary clutch or Secondary clutch not opening up all the way? What do you guys think? I can hit 8,100 RPM easily out of the hole and maybe up to...
  14. REV-XP / XM Chassis - Mountain Sleds
    So I noticed when I was riding last week that my sled wouldn't pull 7900-8000 rpm when I was cruising 30-40 mph Had it to the bars and it would peak at like 7500-7700 rpm. Is it because im already riding at 30+ mph and im just being picky? Or is there something I should be looking into. from a...
  15. REV-XP / XM Chassis - Mountain Sleds
    When go off trail sometimes with the gas wide open, sometimes the rpm drops from 8100 to 6600 for a few seconds then come right back up. At first I thought it was snow on the air filters but it dosent seem to always be the case. I dident noticed it last year. This year I added an slp full...
  16. REV-XP / XM Chassis - Mountain Sleds
    Hello fellow dootalkers, I have a question for you all. Has anyone ever heard a high pitch grinding noise coming from their xp 800r? It only occurs at around 5000rpm and is gone by 5300. I thought maybe it was the secondary or chain case but I eliminated the drive system by removing the belt...
  17. Sled Parts For Sale or Trade
    Item: KOSO Dual EGT gauge w/ RPM/Water Temp Category: Sled Year: N/A Location: Fruitport, MI Price: $400 shipped complete kit and Y-pipe / $300 shipped without Y-pipe and weld in bungs (Free shipping US only) I have for sale a brand new Koso Dual display EGT gauge with all the goodies on it...
  18. MXZ / Legend / Summit / Grand Touring / Formula
    I just picked up my 06 adrenaline 600 sdi and finally got it ready to ride. But I think the rpms are a little high. It idles between 1900-2000. But when I drive it I could be going 40 mph and holding about 7500 rpm and then about 8200 at 70 mph. Is that normal?
  19. MXZ / Legend / Summit / Grand Touring / Formula
    Finally got to 98 MXZ for the first time over the weekend. First impression...crazy bottom end out the hole :eek: .....not so much on the top end. :sad_old: The small area we were able to ride in is 1000ft - 1/4 mile long TOPS. It would only get up to 60-62 MPH, and only spin to 7000rpm...
1-19 of 38 Results
Top