Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. REV Chassis - Performance and Trail Models
    I have a 2005 800HO with a TRA primary clutch. I am adding electric start, but only 4 of the bolt locations are threaded for a ring gear. The other 2 holes are too large to be tapped and appear to be machined that way from the factory. I have been searching and can't find anyone else...
  2. REV Chassis - Performance and Trail Models
    Some ebay starters that I've purchased in the past have worked fine. But the last one I got had a problem hitting the ring gear bolts. Here is how I fixed it: I found flat washer about .075 thick, about .742 od, and drilled the id to 31/64 (.484). I installed it between the spring and the...
  3. MXZ / Legend / Summit / Grand Touring / Formula
    I recently picked up a 1995 Grand Touring SE with the 670 in it. The sled had a starter and battery already on it but no ring gear for some reason. I picked up a ring gear for it and a new battery. Made sure the starter still worked and after cleaning the terminals on it everything was...
  4. REV-XP / XM Chassis - Mountain Sleds
    Hi Everyone, I have a 2009 Summit 800R. Recently while I was out for a ride with my family I heard a dinging on the clutch side of my sled. I opened up the side panel and seen that I had a bolt twist off in the starter frame and the electric start motor was moving a little under the...
  5. REV Chassis - Performance and Trail Models
    hi, new here but so far these forum are very helpful. i'm looking for a little info on a electric start install on my 04 mxz 800. mainly torque specs for the ring gear and primary clutch. any info would be greatly appreciated.
  6. Skandic / Expedition
    My father recently purchased a PB80 clutch for his 2003 Skandic WT 600. Upon removal of the ring gear off the stock TRA he found that it won't fit on the PB80. Is there a ring gear you can purchase for the PB80 or is he out of luck? Any help appreciated!!
  7. REV Chassis - Performance and Trail Models
    I have an E-start kit that i never got to put on due to sled blowing up today. Looking to see if anyone would want to purchase it? Here is what is included 1.New starter (aftermarket) 2.Solenoid (OEM used) 3. Ring gear (OEM new) 4. Long battery cable (OEM used) 5. (1) short ground cable...
  8. Mach Z RT and MXZ 1000 SDI Models
    I just bought my second Mach Z (loved the first one) but this one does not have electric start. Can anyone tell me what I am looking at to put a starter kit on it? Does the wiring harness accept the starter already? Is it just a case of finding a starter motor, ring gear and solenoid or is...
  9. REV Chassis - Mountain Sleds
    I normally just read stuff on here but I an in need on torque specs for the 800r engine (the top end )in a summit as well as advice on how to slide the cylinder down onto new twin ring Pistons I don't have a ring compressor that will fit . as advice on a starter as it does not engage the ring...
1-9 of 9 Results
Top