Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 60 Results
  1. MXZ / Legend / Summit / Grand Touring / Formula
    Sled ran fine about a month ago, brought it in to thaw it out and let it sit while healing an injury. Went to start it no tach, Speedo, or dash; dess doesn’t even beep. Rides fine. Have tail/head lights and odometer. Will be riding and all of a sudden it comes back then look down and it’s...
  2. REV-XP / XM Chassis - Mountain Sleds
    My 08 Summit 800 had an issue out on the trail today. The gauges kept coming on and off and beeping like it was restarting for a few minutes but sled was not dying. I was close to the road so I kept riding easy to try and make it and pick it up there. Before I made it too the road, the sled...
  3. REV-XP / XM Chassis - Mountain Sleds
    Hello all newcomer here. I have gotten a lot of info from here and am stumped on what to do. 2009 summit everest 600 ptek 146" dies after riding for about 15-30 minutes i bought it last winter here in the UP of Mi. Ran great all winter I summarized it and stored it indoors all summer and when I...
  4. REV Chassis - Mountain Sleds
    Hey guys. So I am in the process of wiring my led light bar into my 07 summit 800 atm and I was wondering if there was a good spot I could tap into to get the power. I didn’t want to just tap into one of the lights cause I was worried it would make a be headlight dimmer than the other and I...
  5. REV-XP / XM Chassis - Mountain Sleds
    Hello, hoping someone has fixed something similar. My 2013 Summit Sport PTEK blew up last year and burned a whole bunch of coolant. I did a crank exchange, replated the cylinders, replaced temp sensors and put a new dash in. Now when I'm trying to start it up, it backfires when it gets over...
  6. REV-XP / XM Chassis - Mountain Sleds
    I was doing some pre ride maintenance on my 08 Summit with the 800r PTEK and noticed my clutch had some movement up and down. Pulled it off and can move the crank up and down by hand. Obviously this seems bad. I'm assuming the bearings are shot. Sled will still start and run fine even did 20...
  7. REV-XP / XM Chassis - Mountain Sleds
    Hey fellas, i was wondering if someone would be able to help me with a fuel consumption issue I am having with my sled. its a 2008 800r ptek summit and its just burning way too much fuel. Ive done a complete clean of the carbs and everything seems to be functioning right, I'm not sure what...
  8. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I just noticed the bottle on my sled is empty. Any recommendations where I should look for leaks? Can i just add coolant to the bottle or will that create air pockets? The sled is new to me from a friend of a friend, I have started the sled this year but have not taken it our for a ride yet...
  9. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    I just noticed the bottle on my sled is empty. Are there any known places I should be checking for leaks. How should i go about refilling the system? Should i run the sled and get it up to temp before making any changes? Cheers Ryan
  10. Sledding - General Discussion
    Hey people, I was wondering if a summit 800r ptek 2014 with less than 3000km worth 4200$ is a good first sled? I want to do some trail but also off trail. Sometimes I'll be riding two people on it also. My father keeps telling me to buy a 4 stroke because I'm no mechanic. There is also an...
  11. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    2009 800 ptek renegade. So earlier last week I was riding along and all of a sudden I lost drive and could hear the belt aggressively slipping. I stopped immediately and saw that the clutch sheaves were pretty much all the way open. I took off the belt, inspected it, and put it back on and then...
  12. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Like the title says!! I did a few searches and didnt find too much info. I was out riding a couple weeks ago it was pretty cold -20C. No issues! I let off from a WOT pull and the sled held around 6000rpm gave it a couple blips of the leaver and nothing! CRUISE CONTROL. Hit the kill switch...
  13. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    So I'm not sure if this has anything to do with my failure, but figured I'd run it by you guys to see what you think. I may be off base saying the bearing buddy failed, but what appears to have happened is the cap that plugs my fill hose came off and the hose puked some isoflex, and appears to...
  14. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Bought this sled in July been going over it since. Before I bought the sled I did a compression test. I bought my compression tester at Crapy Tire so I don't exactly trust it. The test read about 120psi each side (throttle closed), I don't remember the exact readings, but it was in that ball...
  15. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Hi guys, I noticed that Goodwin Performance has a P-drive clutch that works on the 800 pteks and etecs. I was just wondering if any of you guys have tried it? I'm looking at getting a whole new clutch setup anyways as mine is worn out. I know the P-drive is a wicked good clutch so as far as I...
  16. REV-XP / XM Chassis - Mountain Sleds
    I've read ALOT of comments both on DooTalk and other sled forums researching the options for reeds on my '09 Summit with 800R Ptek engine but there's still not enough out there who have experience with the new 85F Rage Cage with the aluminum boot and I'm looking for advice. Just as many say the...
  17. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Looking at getting my engine completely rebuilt in my 800r Ptek over the off season. Just can't decide which route to take. The sled definitely should have the crank rebuilt as the sled has 12300 miles on the stock bottom end. I rebuilt the top end about 3000 miles ago, didn't blow just did it...
  18. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    2009 Skidoo MXZ 800r 6000 Miles. As i was riding across the lake the other day, my sled started to overheat and coolant was spitting out of the overflow hose. After further investigation i found that my heat exchanger was only hot on one side and ice cold on the other side. Towed the sled back...
  19. Sled Parts For Sale or Trade
    Item: 800 Etec top end for sale Category: Sled Year: N/A Location: Canada Price: $950 Brand new cylinder with a set of dual ring ProX pistons and a gasket set, includes everything in photo, $950 US shipped within North America. Fits all 800 Etec and will work on Ptek models as well
  20. REV-XP / XM Chassis - Mountain Sleds
    Hello, I have a 2010 summit and the rivets attaching the front rad keep popping off after only one ride out. anyone have this problem and/or a solution?
1-20 of 60 Results
Top