Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 20 Results
  1. REV-XP / XM Chassis - Mountain Sleds
    I'm new to sledding and working on these engines so I need some guidance on what my issue is. I have been on 3 trips mountain sledding with this thing and it was starting first pull the first time. It sat outside for like a month after the first trip and since then it has been incredibly hard to...
  2. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Hi, I am at a lose here.. I rebuilt my 2010 MXZ TNT 600 Carb last year. Over the course of this winter, I noticed I was slowly loosing coolant from the reservoir and figured there must be a leak around the head gasket as many would suggest its a common place.. I do a pressure test and it does...
  3. REV-XP / XM Chassis - Mountain Sleds
    Hey guys I have a 2012 skidoo etec 800 that started out 100 percent un modified then it blew up and I've installed a ptec cylinder in its place drilled oil ports for rave valves and have no problems with it except when I come off the throttle on wide open pulls it slightly backfires on its...
  4. REV Chassis - Performance and Trail Models
    My 2004 ski Doo gsx sdi (fuel injection) model has a fuel problem. Just went through the entire sled all is set. But once the fuel tank gets to or below 1/2 tank it will stall and spitter at high rpms. Idles perfect still. Put a fuel gauge on it, rode it, and the pressure drops. I took the pump...
  5. REV Chassis - Performance and Trail Models
    Hello I got a problem with my Skidoo Mxz Xrs 600sdi HO. The problem started from nowhere about a half year ago. I tought I did run out of fuel but that was not the case. The problem was that it was really hard to start and when you got it to start it would run really bad. Another problem was...
  6. MXZ / Legend / Summit / Grand Touring / Formula
    Hi all. Just purchased my first sled 2006 renegade 1000 had my first run this past weekend. Ran great for the day but the last bit of riding it began to hesitate when hitting the throttle. Got it home and it got worse. Idle very low, headlight is flickering at idle, stalling out and power isn't...
  7. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Hey, Just picked up a 2012 bcx 600 etec and I am having issues with the clutch. It will engage about 3200 and start pulling. The rpms increase from 3200 to almost 5000 and it doesnt go any faster. Stays about 20 km/h. I watched the clutching and after it engages the primary stays where its at...
  8. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 2013 Grand Touring REV XR 600 ETEC. I have a Candoopro and Its giving me a fault code of P0608 Sensor 5v too low. what could be the problem here? Have the RAVE or the TPS sensors gone bad? Would the Capacitor have anything to do with this system? What could I check in order to have this...
  9. REV Chassis - Performance and Trail Models
    Hi,I have an 04 rev 800 ho. Last Saturday I took it out for around a 30 km ride. It ran perfect all day. After that i rode over to my friends house and shut it off. It sat for probably an hour. When i was ready to leave, i started it up and it ran fine for about a minute then it suddenly had no...
  10. Mach Z / Mach 1 / Formula III Triples
    I have a 98 machz and I keep on going threw vault age regulator but they stopped making them and can't get a aftermarket one. What can I do or check or has anybody just changed it to a 99 setup I'll try anything love the sled.
  11. REV Chassis - Performance and Trail Models
    So I recently put an HID kit in my 05 600 SDI. The problem is that on start up the draw from the HID lights is so much that it does not allow the sled to start. If I pull the fuse on the lights it starts up just fine. My question is if there is a type of delay I can place on the lead from the...
  12. REV Chassis - Performance and Trail Models
    Well, went out today for a long ride, Got 325 flawless Kilometers in today on some nice trails. On the way back, about 50 kms away from home my battery light started flashing And the beeper was singing the song of it's people. Got about 5 kms after that and then a rev limiter kicked in a...
  13. REV Chassis - Performance and Trail Models
    I just installed a cyberdyne temp gauge in my 800 gade reads fine when idling but when you throttle it up at all it kind of goes wild and flashes a - sign and some numbers when you go back to idle it resets and reads fine .. Anyone else had these issues. Thanks
  14. REV-XP / XM Chassis - Mountain Sleds
    so I was thinking about getting a used 2010 summit Everest (I think) 600 146 and I was wondering if there was any specific problems with that sled. I was also considering putting a full wrap on it does that require lots of time and are the SCS unlimited wraps any good? The price seems a little...
  15. REV-XP / XM Chassis - Mountain Sleds
    i got my 2008 ski doo xp and when at idal and i make it rev higher without moving, it would say that im going over 10 mph? plus the gas gauge only reads the first half tank of gas? is it the modul? i have no clue!
  16. REV-XP / XM Chassis - Mountain Sleds
    So my check engine light is coming on above 6000 rpms without a real loss of power. No sputtering, everything feels generally ok. Any ideas? I'm riding a 2008 summit 800 x with oil delete and a few other mods. I'm thinking electrical but not really sure where to start....Thanks!
  17. Mach Z RT and MXZ 1000 SDI Models
    I'm going to look at this sled tonight. It is completely stock, only has 2800km, never needed service and looks like it came off the show room floor. I only decided to look at a 1000 yesterday so I haven't had much time to research this sled but I have read the crank problems and some of the...
  18. REV Chassis - Performance and Trail Models
    hi i took my sled for a run today and the check engine light was on.. when i would go full throtte it would like cut 2 times at 6000 ( like waaaaatata) ahah and would then open up... and when i push the reverse button it stalls... but that might be my compression.. but what could make the check...
  19. REV-XP / XM Chassis - Mountain Sleds
    hey gang, i just wanted to start this thread as a catch-all for people who have had any issues with their new XM's so far. i am mainly concerned about manufacturing/engineering/quality defects. I am definitely a firm believer in BRP quality and am quite loyal, but lets face it, stuff...
  20. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    As of last Friday I bought a 2013 MXZ Sport 550 fan from a local dealership. The sled looks awesome and after not having one last year when all my friends were out, I was excited to get mine. The problem is, when i first start the sled, even after putting the choke on, the skidoo seems to not...
1-20 of 20 Results
Top