Ski-Doo Snowmobiles Forum banner
problem
1-20 of 35 Results
  1. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 2002 mxz and when I switch to my high beam they are really dim. When I am cruising they work fine. The low beams work fine on their own but sometimes will just completely shut off. I want to know if anybody else has had this problem and would know how to fix it.
  2. Skandic / Expedition
    Hi I don't know exactly how to explain that but I need some advice Since my last 2 to 3 rides my 2019 Ski-Doo Expedition Sport REV GEN4 900 ACE give me some weird sound will putting full throttle to get out of the snow. The sound is around 1/2 sec long like a grinding sound and after that...
  3. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    My etec 800 from 2011 starts and works normal in every way, beside that every time I let go of the throttle and rev starts to sink and are supposed to stay at idle 1200rpm, It just passes that point just like the snowmobile doesn't have any idle. The result is that the engine dies every time i...
  4. MXZX Race Sleds
    I have a 2007 mxzx 440 that has been going back and forth from running perfect to bogging at all times. I recently had a bogging issue and discovered it was only running rich. So, I raised the main needle to the highest position (it was on the 2 from the top) and after that it ran like a champ...
  5. REV-XP / XM Chassis - Mountain Sleds
    Hi! I bought a complete, but used, Straightline Performance (SPI) 860 e-tec big bore kit for a 2014 Freeride. Ive installed it but I'm now having issues with the fuel controller. It seems like the settings doesnt get saved when I restart the sled. I enter the changes and let it go back to the...
  6. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    Hello everyone! I'm struggling with my Freeride.. Ended up being towed by other Skidoo. I'm pretty sure my stator is damaged someway! I put link to the youtube video to show you what really happened. It didn't even start anymore as you can see. Sled gives good spark to both cylinders. Minutes...
  7. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    hey there! I happen to have a real problem on my 2010 renegade 800r ptek. the problem is that the sled seems to miss some spark on one cylinder(clutch side). When I go WOT chek engine comes ON and after a scan at BRP its the knock sensor. When I put it in reverse, the problem is worse. Its hard...
  8. REV-XP / XM Chassis - Mountain Sleds
    Anyone experienced this or have any suggestions? After 30-45 seconds wide open on hill climbs, my engine loses power quickly and dies. If I'm in a committed steep hill climb spot, it's scary. If I immediately turn back downhill, it recovers and runs fine until the next climb after being...
  9. REV Chassis - Performance and Trail Models
    Looking for some direction from you experienced sled owners that have had electrical problems. I picked up a used 07 Rev with 600 SDI elect start. Sled is running like a champ but in my last outing I blew 2 break lights and lost my thumb & hand warmers. We were sledding in negative 10 degree...
  10. MXZ / Legend / Summit / Grand Touring / Formula
    Hello Ski doo gurus! Im new to this forum but are in need of major help. I bought a 800 2001 highmark x last year, quite alot of mileage on it but it worked like a charm my first season with it. But this summer i bought new wiseco forged pistons because of the mileage. I hooned my cylinders and...
  11. MXZ / Legend / Summit / Grand Touring / Formula
    Ive had my 03 Legend for 2 winters now and it ran 100% the first year, never gave me one bit of trouble. the 2nd year i put a Sno-Stuff Rumble Pack can on the sled and it started to give me problems after about the second drive.. the sled runs on 1 cylinder or bogs if im cruising or anything...
  12. REV Chassis - Performance and Trail Models
    I have just rebuilt my 2003 skidoo rev 600 HO 3 days ago ( 140 psi both sides ) and i went to do my 3rd heat cycle and its been running like (excuse my language) complete $&@$ Its been backfiring on start up and it idles very low but i hear the 2 beeps on start up. I tried starting it again and...
  13. MXZX Race Sleds
    When the sled is shut off the needles is not at 0, they should not be so I think. this is the best pic I have right now When I start it up the speedo needle goes up and then down and I can hear the usual two beeps but the tach is not going up and then down all the time, only sometimes and when...
  14. REV Chassis - Performance and Trail Models
    Got an 05 gsx 600sdi and after rebuild it Ran good for 500 feet then acts like a bad injector. Revved it up pretty good. 135/140# compression. Good spark. Did exactly the same thing last time, this is the second fuel rail and injectors. Doesn't go into reverse well without stalling either. Any...
  15. MXZ / Legend / Summit / Grand Touring / Formula
    Hi everyone. First off thanks for looking at this post. My problem is finding the timing mark on the magneto to time this motor with a timing light. I can find the little dot on the trigger point no problem. I have this lined up on the middle of the trigger at .083 btdc. The problem I have...
  16. REV Chassis - Performance and Trail Models
    I just installed 37" AI a-arms on a 2006 Renegade. Some things I wish I had known and some questions: -Buy Summit steering rods or tie rods- you will not need to tap as far. Cutting 2.5" was suggested but that brings you into the adjustment notch for the alignment. The aluminum becomes...
  17. REV Chassis - Performance and Trail Models
    Hello guys and gals! Im having major problems with my sled since a engine system transplant last spring. The sled was has had it's original engine, carbs, clutches, exhaust & cable stem swapped from a 04 600HO, and a MPEM from another 600, might have been from a 500ss engine, I can't recall...
  18. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Hey guys so I am new here and this is my first Ski Doo. I picked up a 2009 600 Etec MXZ TNT from a local guy here in downstate MI. 3400 miles. One owner. Clean as hell. I took it to K&W Cycle to get a preseason check up done. Dec 5 a group of 10 of us headed up to Wetmore to hit the...
  19. REV Chassis - Mountain Sleds
    Rode my summit all last year with no problems that have anything to do with this. When I pull the cord 95% of the time there's no spark and rarely there is on one plug. Bought and changed the ignition coil (black assembly that goes on top of the plugs) with no change in result. Brand new plugs...
  20. Sledding - General Discussion
    I have bought a 2008 mxz tnt 500ss and the clusters wires were torn out in an accident. i have tryed to use the shop manuals wiring diagram but there are 2 problems: 1. the wiring diagram shows 14 wires and i only have 10 wires 2. the colors dont match up, i have: 1 grey wire 1 red wire with...
1-20 of 35 Results
Top