Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 27 Results
  1. Sledding - General Discussion
    Has anyone found a set of speakers that fit in their BV2s helmets? The only thing I can find online are the Collette micro blaster speakers that are suppose to fit in the helmets. But I can't find any reviews on those. Wanting to hear some music now that I don't have to listen for my 2-stroke...
  2. MXZ / Legend / Summit / Grand Touring / Formula
    Hi, Need some help solving this issue. Brought sled home from trip north (last Feb) where it started ok but occasional relay chatter. It sat outside uncovered for 2 weeks. Tried to start it, wouldn't crank. Didn't ride again so it sat (inside) till now. Battery not that great so have good...
  3. Alberta
    My 2004 Summit 800 Shut off while I was riding. I tried to pull it over and the pull cord came out but would not retract. When i got it home i tried turning the primary clutch and it will turn by hand until a certain point then i need to use a bar but then it frees up again. When i turned the...
  4. REV Chassis - Performance and Trail Models
    i have a 2005 mxz 800 ho i cleaned the carbs for the first time since i have owned it. i took them complete apart and have a spare set. I took the spare set apart and they have a smaller main jet it is a 20 didnt see the number 4 in front of the 20. But in the carbs i took off the sled it is a...
  5. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    I hearing a noise in my 800 etec backcountry 2012. About 4500 to 5000 km. I can't find out what it is. Sounds like metal rotating almost like old loose heat plates ticking off something. It's hard to describe. It happens when power comes on. Worse in deep snow. Hear it a lot when coming out of a...
  6. REV Chassis - Performance and Trail Models
    just got back from up north this past weekend and had a blast the 2005 mxz 800 ran great till about 30 min in the trail i noticed that when comming up to a stop sign i had a high ideal around 3000 +/- till i hit the throttle and it would come back down to aroun 1600-1800. still ran fine. also...
  7. REV Chassis - Mountain Sleds
    i got a 144 and looking to make it into a 146 can i easily swap it just by 2.86 drivers with a 9in wheel on the 144 rails to fit the 146
  8. REV Chassis - Performance and Trail Models
    well i have a 2005 800 mxz 800 ho and it ran fine the other day i put new exahust gaskets on it and changed the cain case oil and had to wire in an after market off switch was tired of messing with the stock one and started it up and when it hit the throttle itwont rev up.
  9. Vintage Ski Doo's
    I'm about to paint the pan on my 76 Rv 340. I want it to look as factory as possible but not sure if the rivets that hold it to the tunnel should be painted over in black. Any help on this would be great. Thanks for any info.
  10. MXZ / Legend / Summit / Grand Touring / Formula
    I need some help please from the clutch guru's I have a team clutch with this helix in it and a red spring that has 120 220 spring would this be a good setup for trail riding sled is a 00 mxz 700 with manual reverse track is 136 1 1/4 paddle gearing is 25 top 44 bottom pic's of...
  11. Vintage Ski Doo's
    I need to pull a 102C off my RV motor, I don't have the "special" puller. Any tricks for a home made puller would be great help. Thanks.
  12. REV Chassis - Performance and Trail Models
    I have a 2008 MXZ 550F that i just purchased this year. The machine will right out of the blue just stall, just as if you turned the key off. As it rolls to a stop you can reach down and turn the key off and then back on and restart the sled.(electric start model), It has done this everytime i...
  13. REV Chassis - Performance and Trail Models
    I was on my 550x on the lake today at 40mph it lost power and went in reverse then forward and back .like it was caught in a loop.i disconnected the l/s connector that goes to the rev.switch no change and moved all other connectors no change.did it 5 times every time you try reverse it acts...
  14. REV Chassis - Mountain Sleds
    So.... My sled has over 8200 miles on it, the chassis is beat to crap but never wrecked. My motor just has last seasons miles (2k) and I want to get one more season out of this sled. Because she is pretty beat up, I decided to go lightweight and drop everything that isn't necessary. I'm building...
  15. MXZ / Legend / Summit / Grand Touring / Formula
    someone how has install non slip on the zx shaft and can tell me the messurings where the sprockets are going to be on the shaft?
  16. MXZX Race Sleds
    I've recently went to the dealer to see why my engine light was on, 50$ later I had the diagnostics. He told me to get the Exhaust Temperature sensor 313$, and the air temperature sensor 22$. Engine light is still on. Do I need to go get the system reset to take the light off? Or do I need more...
  17. MXZX Race Sleds
    I got a engine code comming up for a air pressure sensor, im wondering where this is located to? It is not the one in the tube going from the air intake box into the air box its self. 2011 600RS
  18. Vintage Ski Doo's
    I had lost a bogie wheel, I do not know what size I should get for a 1991 ski doo formula plus. It is the one one the outside, but in the middle of the track. I see some on eBay but i don't know if it would be the right one.... Or does anyone know where I can find one????? Thanks Zack
  19. MXZX Race Sleds
    2011 MXZ 600rs: Recently the engine light came on, no code pops up it just blinks,check engine comes up across the screen and it beeps 4 times. I checked the exhaust valves, compression, and carbs. I am currently running 290's at 0-1000ft and -10C - +5C. 91 Oct, 33:1 Lucas Oil. Plugs are dark...
  20. REV Chassis - Performance and Trail Models
    Hello. I have a 550 GSX 2007. issue with it lately is when I am riding fast its all good. when I stop at a road, it stalls, or trys to stall. I need to shut it off and let it cool for 10 seconds and then it runs fine. even idles perfectly when I restart it? anyone seen this before? compression...
1-20 of 27 Results