Search Results for ‘mxz 800’

HI I ran into a problem yesterday were my sled washing trouble creating spark and I eliminated the problem down to the ignition coil and wires. I am looking online to buy a new set because I don't really want a used set that might also have problem and I was wondering if anyone knew of a set...

Sooo I fired my sled up to take a spin around my yard. Let it warm up in my garage for a few minutes while I’m getting my gear on the sled just shuts off. I try to start it get nothing at all!! So I check for spark an it has NONE. Where do I start an what do I replace first. Coil pack, stator...

Hi I am not at all new to dootalk as I have gleaned an awful lot of information off them before. But I am new to posting! So here goes question 1... I have a 2002 MXZ 800 with 2300 km that I purchased towards the end of last year. This fall when I got her out she wouldn't start so I drained the...

2002 mxz 800 Little backfire on deceleration. Sleds runs great otherwise. So Put on 65 miles today, half way through my ride I noticed as I slowed and let off throttle from 4k + rpms I’d sometimes get a random backfire, just a little pop out of the exhaust. Also noticed the sled is really bad on...

Hi, I recently purchased a 2010 MXZ 800r Ptek. After starting it, it runs great for about 30 seconds to 1 minute. Then once idle for that time, it drops down to one cylinder until you throttle it again. Once it drops to one cylinder, the gauge cluster lights begin to go out, only flickering...

Hey guys, I just rebuilt my 05 mxz 800, it had low compression on one cylinder before the rebuild and about 6000 miles so I decided to do an overhaul. My problem now is after the rebuild the compression is so high I can't pull it to turn it over more than once. If I pull the plugs it turns over...

Hey all, I am working on my 2003 Ski Doo MXZ R. Before i got it someone rolled it and had come some replacement wiring. When I went to install a heated thumb warmer I noticed that when the sled is running or connected to an external 12 v battery the entire sled becomes energized. I'm thinking...

having an issue with my sled idling properly or not at all. there is a idle adjustment that controls both carbs by a single adjustment knob, when i adjust it from there sometimes it will idle up to 4000 rpm and just about engage the clutch if i go too low it will shut off but will show a code...

Ok I blew up my 2010 mxz 800 in Maine this year:( 6200 miles the sled is in very good shape other than the motor Looks like long Block is best fix? Hole in bottom end. Should I rebuil or try to sell? What is she worth? Any help would be awesome Thanks

I just finished a top end rebuild on my 2004 mxz 800 and at low rpm the engine bogs down and tries to die when I hit the throttle. Once the rpms hit 4500 it takes off and runs great but if I'm idling or creeping along it doesn't want to go until it gets to 4500 rpm. I cleaned the carburetor...

I just finished a top end rebuild on my 2004 mxz 800 and at low rpm the engine bogs down and tries to die when I hit the throttle. Once the rpms hit 4500 it takes off and runs great but if I'm idling or creeping along it doesn't want to go until it gets to 4500 rpm. I cleaned the carburetor...

Cannot get my 2004 mxz 800 to start. I pulled it out a month ago and after some effort got it going. I was having a real problem getting it to start for the 1st time of the season and after some fiddleing and research online I spayed some wd40 in the air box and pulled the spark plug and put in...

So i bought an 02 MXZ 800 Renegade from a buddy and the pawl was bad, but he bought a new one for me and i installed it, i rode sled one time(between 50-100 miles) and the sled ate up the recoil, so i borrowed the recoil off my 01 MXZ 700 in order to ride my 800 in the U.P. for the weekend, i...

was out on my 2001 mxz 800 and my rewind starter failed. I hadn't rode this sled in two years and after two or three days the starter failed. when i removed the starter i saw a bunch of melted plastic parts and some metal ones that were all chewed up. I purchased an aftermarket one for $100 and...

When I ride my 01 mxz 800 all the lights dim down.(headlights, taillights, and dash lights) I thought it could be a short in the wired but there all clean and all the connections are good. So I changed the voltage regulator and it still does it. Would it be the stator?? It won't do it at idle...

Hi. I have a 2003 mxz 800 renegade with a trail can and V-force 3 reeds. It does not run clean on the top end. It seems to sputter if you open it up more than half throttle. It runs fine on the stand, it only does it under load. if i ease into it, seems normal till about 60mph but will only...

Re-ringing my 02 mxz 800 (just for preventative maintenance), and the previous owner didn't tell me that he put in dual ring pistons. Sled has only about 2000 miles on it. Please look at the pictures and tell me if they are Cudney, MCB, etc. Any help is appreciated. I only wanted to order...