Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Skandic / Expedition
    I'd like to install a 2010 Skandic WT 550F engine into a 2005 Skandic WT 550F body. Has anyone done this? does the engine fit? On the surface, it looks like it will fit. I'm thinking of buying 2005 Skandic WT 550F body for my 2010 Skandic WT 550F engine. I just want to make sure it will fit...
  2. Freestyle / Legend / Tundra / Expedition Sport
    Good afternoon. I just installed a new fuel pump in my 2015 Tundra Extreme 600 Etec. After hooking all gas lines back up and the electrical plug, I hit the start button and I have nothing. I can't hear the fuel pump click on or anything. Kinda stumped. Any insight would be very appreciated...
  3. MXZ / Legend / Summit / Grand Touring / Formula
    Am I correct thinking that the cabs on my 99 500 fan can have a primer hooked up to the nipples with the rubber caps on them? I know those ports are used for "vacuum balancing" but will it cause any functional issues to hook my primer lines up there? After getting the sled up and running after...
  4. Sledding - General Discussion
    Ok. Here's a way to do this witout special tools. It works well on the left side jackshaft (QRS) and driveshaft (Brake) bearings that are difficult to remove. First, grind off the old bearing with a hand disc grinder. BE CAREFUL NOT TO KNICK THE JACKSHAFT when you are getting to the bottom...
  5. Sledding - General Discussion
    My Wife Kim wanted some taller risers and dampening when riding rough trails and tight woods single track, so SHE added the isovibe to her 2007 mxzx 550. Check it out
  6. Sledding - General Discussion
    Here is a video video detailing step by step instructions on installing the Grip N Rip Racing Upper Rear A Arm & Suspension Module Brace Kit on a 2016 Ski-Doo Freeride 137. These two newly redesigned brace kits install very easily, you will see in the video that there is ample room for tools -...
  7. General Discussion
    Hey guys, is there any way a Ski Doo Formula Deluxe MBRP can will fit a Ski Doo Grand Touring model if the same year. Could not find an mbrp can online for a Grand Touring. Also, how does the 2001 Ski Doo Grand Touring 700 stand in terms of reliability and performance in powder? Thanks, Colt
  8. Sledding - General Discussion
    I have a 2006 skidoo 500ss and purchased the new skidoo handgaurds that have plastic ring that goes over handke bars and a bolt goes through it to tighten all one piece .. i can get the right side to go on , but left side the break cyl/hose is in the way , prevents it from pushing all way down...
  9. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    1+1 xp seat installation instructions...very low quality pictures since it originally was 750kb and i had to compress to 200kb to upload.
  10. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Guys, I just studded my 2009 MXZ Adrenaline and am ready to install the tunnel protectors but I see they are bevelled (skinnier at one end) and I have no idea if the bevelled (pointy/skinny) end should be towards the engine or towards the tail light. In addition, when inserting them (in either...
1-10 of 10 Results