Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. REV-XP / XM Chassis - Mountain Sleds
    I bought this sled with the runner reinforcements already installed, and purchased a set of idler wheels for adding to the rear of the track, but the mounting holes are used for installing the runner reinforcement already. Any other way recommended to install the idler wheels without drilling a...
  2. MXZ / Legend / Summit / Grand Touring / Formula
    Need to replace a couple of the rear idler wheels. Was going to just swap out all of them. Having a hard time trying to find replacement wheels for this sled. Help please!
  3. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I need to replace some idler wheels. I found the rears on Dennis Kirk. However, I cannot find the smaller forward wheels. Are they available aftermarket? Is there a difference between the inside and outside? How about the bearings? Some just need bearings. Not sure how much ski doos...
  4. REV Chassis - Performance and Trail Models
    So I just bought an 04 rev 440/800 this year and i'm having some issues with my rear idler wheels. This has happened to me twice already, after 20 minutes of riding both my idler wheels in the back flew right off and the one in the middle got mangled. I'm also riding on an sc4 suspension that...
  5. REV-XP / XM Chassis - Mountain Sleds
    I was just checking the new XM over for loose bolts and i came across something weird. the tunnel slides side to side on the upper idler wheels when i push and pull on it, but it does not do it on the XP. Is this part of the TMOTION? you can actually see quite a bit of slop side to side where...
  6. REV Chassis - Performance and Trail Models
    Been wondering this for a while now and even considering doing this. Why do people remove the outside wheels on the rear axle? What are the benefits of doing so. Since I only have one wheel in the middle (why does Doo do that by the way??) I would have to add another wheel. How hard is it to add...
  7. REV-XP / XM Chassis - Mountain Sleds
    This is a two part question. Last spring I purchased a used 2012 Freeride 137. This is my first XP chassis, as my last sled was a 06 Summit. 1. Upon disassembly of the rear skid I noticed there are two sets of mounting holes for the two forward outside idler wheels as well as the center inside...
1-7 of 7 Results
Top