Search Results for ‘high idle’

Hey guys I have a 94 formula z 583. Just did carb clean and set air screws to 2 1/4 turns out. Started sled and it fires up but needs primes to keep running until warm. Once warm it idles up to 4000rpm. Primes bring it down but it goes right back up. So I turned screws to 1.5 turns and nothing...

Hi everyone, new to this forum. My son just got an 04 500ss and we have 2 issues I'm seeking help with. First, when we bought the sled it had a small battery in it so I got a new one. After this swap the guages stopped working. Any ideas? Second, we just put an mbrp trail can on it and...

I have a 96 Grand Touring 580, Engine was redone last year and it ran great, got it out of storage this year done a couple of trips around the house to loosen it up and now it idles at 3500 rpm. On initial start up its fine, but as soon as I touch the throttle it starts to race. I looked at the...

So i figured out this machine so far. Nothing wrong with the engine or clutches. But i just want an answer on carb boots leaking. Would this cause for high idle like 6k rpm ? Would replacung the boots fix the high rpm problem ? Throttle seems fine , compression 140 , clutches may need aligning...

Hi guys, I haven't had the sled out much at all this year, but I did manage to get it out in the field behind my house. I noticed for the most part that the idle would stay up around 3,000 unless I did a sharp jab or two to the throttle and then it would settle down to around 1700-1800. I had...

So I just got my skid back in tonight and went to take it around the yard to see how the fresh shocks feel and it would not idle down below 3000 rpm. I was hoping someone might have some insight as to what I might start with getting this resolved. thanks in advance

Hi There, I have a 2010 mxz 600 sport so it has the carb 600 and I am having issues with it idling. I just finished doing a top end from the damage that was a result of the current set up. The sled is idling about 2100 and i turn down the idle screw and it will go down for a bit then back up. If...

so heres my story, first part is whats been going on the last few weeks and what I did yesterday, second part is what ive done today. so here we go (note everything you read until I state otherwise was done yesterday) my 89 mach 1 583 rave has been running good lately. about three weeks ago i...

Looking for some feedback on an issue with my 2010.5 800 ETEC MXZ X. I recently had a piston recall completed on my machine. At that time the dealer recommended that I also change the reeds so I replaced the original with a boyesen rage cage. When I got the machine back after about 10-15 mins of...

Purchased a new 2012 last year missed one season due to snow. Fogged and ran fuel out. Put several hours over the holiday have 2500 - 3000 idle. Sprayed carbs with Sea Foam and treated fuel ran a 3/4 tank thru with treated fuel. No change. Also put the Premium Elect Guage BRP# 860200592 on...

Purchased a new 2012 last year missed one season due to snow. Fogged and ran fuel out. Put several hours over the holiday have 2500 - 3000 idle. Sprayed carbs with Sea Foam and treated fuel ran a 3/4 tank thru with treated fuel. No change. Also put the Premium Elect Guage BRP# 860200592 on...