Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 14 Results
  1. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I have an issue with my handwarmers not working. I have a 2010 Renegade 600 Etec. Thumb warmer doesn't work either. On my last ride of the season when the handwarmers would quit working I could pull on the steering wiring harness a bit and they would start working for a while again. Then...
  2. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I have a 2013 backcountry 800 second owner previous owner told me he had x gauge installed instead of taking $$$$ back at time of purchase he added x gauge and spare fuel tank and travel bag the issue I have is no hand/thumb warmers show on the gauge and do not work every other feature...
  3. REV-XP / XM Chassis - Mountain Sleds
    Right side handwarmer on my 2014 freeride sucks. Both sides work but the right side one is barely on. You feel it get a little warm when idleing in my garage but feels like it isnt even on when riding. even when turned all the way up. The right hand one kinda sucks too but Gets warm enough for...
  4. Vintage Ski Doo's
    I am currently sprucing up my 85 SkiDoo Safari 377E for my 8 yr old grandson. He looks at my sleds....[2] 04 500SS GSX's.....and always wants what is on them. I hooked up a shield heater plug and have put heated grips on as well. It is where to get power for the grips that I am looking for...
  5. REV Chassis - Performance and Trail Models
    Went to replace my handwarmers,on 2006 mxz500ss bought OEM set OMG! who design these! the wires are twice the size,you will need to drill your throttle handle out to 1/4" for wire to come through to put on (Soap don't work). Found black permatex on bars and in handle works best. Don't hammer...
  6. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Hopefully someone else has had this issue. I have had my 500ss gtx sport skdoo for 5 years now. Suddenly this year my hand and thumb warmers stopped working altogether. Since they all quit at the same time I assume it's a voltage problem. I have checked the fuses. They are all fine. It was...
  7. MXZ / Legend / Summit / Grand Touring / Formula
    Hello, I am interested if anyone has converted the hand warmers to additional lights on a 97' Formula 500 with the 494 in it? If so where do I start with this process as I have the old hand warmers removed from a bar riser extension already. I was informed that I could get a conversion kit to...
  8. REV Chassis - Performance and Trail Models
    Hi, I have a 2006 REV 600sdi and I've been having an issue with it blowing the accessory fuse that runs the handwarmers brake lights and tail light. I've found that the red and yellow wire at the tail light had a connection to the fuse and also through the chassis. I removed the tank and found...
  9. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I put my 2012 600 etec backcountry in for general service and asked them to install an 8" riser. When I got the sled back the handwarmers no longer worked. Returned it to the shop and they told me it was an ECM failure and that my 12 volt would also not work. The dealer said the electrical...
  10. Sledding - General Discussion
    Short background story... Last weekend (after rolling sled a few times) my RER began to short out on my summit. I was able to dry it out the first two times it happened, but the third time apparently wasn't the charm. After about 30 mins of attempting to dry it out, as well as pulling fuses...
  11. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Bought this 2013 800 etec last year and put 700 mi on it. I had a thumb warmer put on under warranty because it quit. this year, I rode 20 mi around home and had 0 issues, they worked great. As I was looking it over to take it up to MI, I went to turn my hand warmers down because I had them...
  12. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 2003 mzx 600 zx and when I bought it the all lights and hand warmers were working. Found them not working one day and found the dimmer switch was not clicking so I took apart and it was melted. Bought a new one and everything worked. Took it out this week for about 45 min with no...
  13. MXZ / Legend / Summit / Grand Touring / Formula
    I have a 2003 mzx 600 zx and when I bought it the all lights and hand warmers were working. Found them not working one day and found the dimmer switch was not clicking so I took apart and it was melted. Bought a new one and everything worked. Took it out this week for about 45 min with no...
  14. MXZ / Legend / Summit / Grand Touring / Formula
    I want to change my handlebars on my 2001 mxz 500 and i dont think ill have a problem changing the brake and throttle body but im not sure about the handwarmers. are they just pads under the grips that i can put on the new bars or are they right in the stock bars?
1-14 of 14 Results
Top