Ski-Doo Snowmobiles Forum banner
gsx
1-20 of 51 Results
  1. REV Chassis - Performance and Trail Models
    I just got a 2004 Ski-doo GSX 800, not sure of the trim. I am told by the previous owner it has a bad voltage regulator. How can I test the voltage regulator and what symptoms can occur, currently the E-Start and reverse does not work. It also has this weird thing, when you put the key on and...
  2. REV Chassis - Performance and Trail Models
    I have a 2005 GSX 600ho SDI that needs a top end. I also have a 2001 MXZ 600. How hard would it be to put the 600 from the MXZ into the GSX? Has anyone done this type swap before? I would basically have a GSX 500ss in the end. Will the motor bolt up? Any big issues I might run into? I was going...
  3. REV Chassis - Performance and Trail Models
    Hello, I have a 2006 GSX and I needed to replace the jackshaft because the shaft was turning inside the bearing and is now all worn out. I took everything apart but my question is how many washers are behind the chaincase on the 3 studs? How do you align it? The parts diagram says 6 washers on...
  4. REV Chassis - Performance and Trail Models
    Good Day all...my wifes 600 HO had issues with the E start working at the end of last year...pull start it and it ran perfect. took the battery out prior to summerize. Now I have trickle charged the battery...it tests good with the tester. put battery in, hook everything up and hit the button...
  5. REV Chassis - Performance and Trail Models
    My 2004 ski Doo gsx sdi (fuel injection) model has a fuel problem. Just went through the entire sled all is set. But once the fuel tank gets to or below 1/2 tank it will stall and spitter at high rpms. Idles perfect still. Put a fuel gauge on it, rode it, and the pressure drops. I took the pump...
  6. Sled Parts For Sale or Trade
    Item: Upper A-arms w/ball joints for 42" front Category: Sled Year: Natalya Location: Hagerstown, MD Price: 100.00 These came off a 2012 GSX, but should fit any GSX, MXZ, Renegade with 42" wide front end. They are silver, but could be painted to match what you have. A-arms are $144 new, and...
  7. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Back ground - 2010 Ski-doo GSX 550F, 7000 miles lost PTO side piston, Replaced top-end sled started and ran my son drove 20 miles sled locked up turns out lost crankshaft didn't know Rev XP need new isoflex grease after time. Current State - Pulled motor took it down split crankcase replaced...
  8. Sledding - General Discussion
    OK, so over the weekend I installed the OEM BRP temperature indicator module, Ski Doo # 860 200 629. I installed this on my 2011 GSX 600HO Etec which has the premium gauge cluster. This module is supposed to enable the gage pod to display bars (similar to the gas tank level) to indicate a...
  9. Sleds For Sale
    Item: 2009 GSX 550f $1800 Category: Sled Year: 2009 Location: New London, Iowa Price: 1800 For Sale: 2009 Ski doo GSX 550f. Good condition Electric start/Reverse. brand new carb boots and carbides, fresh top end. . Contact# 319 nine three one seven zero one eight...
  10. Sledding - General Discussion
    Happy New Year from Quebec. I haven't been on a snowmobile in about 25 years, sleds have changed a lot since then! I am keen to get back into the sport, tons of trails very close to where I live. 3KM away I can get on the main Quebec trail and go pretty much anywhere. I have about 7K to spend...
  11. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    I have spent numerous hours on a track swap on my 2012 GSX SE. Installing a 1.75" lug paddle track. I realized that I was so excited about the potential flotation & traction of the 1.75" x 16" track that I neglected to consider the width being an issue with the Air lines for the air shock! Can...
  12. REV Chassis - Performance and Trail Models
    Hello fellow sledders. I was out today in my 04 GSX 500ss playing in fresh powder and doing some carving. I was having some fun when i noticed my sled was going all the way up to 9000RPM with only a little bit of throttle. it sounded horrible and I wasn't getting all my potential power. How can...
  13. REV Chassis - Performance and Trail Models
    always run sled engine mid summer. fuel is treated. season prep is, new NGK plugs, top off all liquids, tended the battery. I've already installed the assist oil pump return spring. Is this a thing that ski-doo won't admit to like the carb boots that crack, suck air, and run engines lean, ending...
  14. REV Chassis - Performance and Trail Models
    When the season is over I am planning on replacing or servicing the center and ski shocks. I was just wondering if they were rebuildable? What are some good alternatives? Not trying to spend too much either. I've been looking at the Kimpex Nitro ones. The part number for the ski shocks are...
  15. REV Chassis - Performance and Trail Models
    I heard the dreaded "screech" noise when I turned my clutch by hand on my 2005 GSX 600 HO SDI. Sure enough from reading the posts on here I have a broken magnet in the flywheel. Original Design. Anyone have an updated one piece magnet flywheel for sale ? I live in Michigan. Thanks, Darren
  16. REV Chassis - Performance and Trail Models
    hey guys, just got a new sled (04 Rev GSX500ss) and im having some problem with the oil level sensor or some sort of oil injection related sensor. ive been through the carbs, rebuild the fuel pump, new tank fuel filter and blew out all the fuel and vent lines, new carb boots, welded and patched...
  17. REV Chassis - Performance and Trail Models
    Ok so I have a 2006 GSX 600 HO SDI Ski-Doo studded track. So my problem is when I go on powder snow and really give it gas like over 8000 RPM, it feels like something is skipping or ratcheting right below me. It really feels like I am going over rocks. I have tried to tight the track but it...
  18. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    This is probably a shot in the dark but I thought I'd see if any of you GSX owners tried to do the same thing that I am with a 1+1 heated seat. I have a 2012 GSX SE with a heated seat. I just installed the LinQ 1+1 Complete Seat System with the Heated 11 Grip with Guard. I got the +1 seat used...
  19. REV Chassis - Performance and Trail Models
    This is probably a shot in the dark but I thought I'd see if any of you GSX owners tried to do the same thing that I am with a 1+1 heated seat. I have a 2012 GSX SE with a heated seat. I just installed the LinQ 1+1 Complete Seat System with the Heated 11 Grip with Guard. I got the +1 seat used...
  20. Sledding - General Discussion
    Any thoughts, knowledge about the difference between BR9ES and BR9ECS, I run an 06' GSX 500ss. Also when I purchase the ECS at Napa they are gapped around 0.030. I've read they should be 0.031 and 0.018???
1-20 of 51 Results
Top