Ski-Doo Snowmobiles Forum banner
grease
1-7 of 7 Results
  1. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    I just took the primary off my 08 mxz 600 ho sdi and found this lump of what I think is belt fragments, crud, grease. Is this iso-flex that may have made its way out through the seal? I took the clutch off to see about getting the grooves machined out of it and to clean up under the hood. I...
  2. REV-GEN 4 - Summit/Freeride/ 850 Turbo
    Dripping oily greasey black substance onto my skidplate and then dripping on the floor leaving a small pudddle?? What is this from? Just picked two 18 Freerides up and both are doing it. Both have skid plates installed.
  3. Sledding - General Discussion
    Just wondering what everybody uses to re-grease their idler wheels and jackshaft bearings. I removed my jackshaft to address a clutch alignment issue and thought that while I had the bearing off of the shaft I would repack it. I popped the seals out and cleaned out the grease and re-applied...
  4. Skandic / Expedition
    Hi folks, Trying to get some info on how many grease fittings/zerks are on my machine and where they are located. I was able to find two (one apiece) on the front suspension, but I didnt see any on the rear, nor any up in the tunnel anywhere. I do not have a service manual (prolly should fork...
  5. MXZ / Legend / Summit / Grand Touring / Formula
    ok so just relized when i put my crank back in i forgot to put isoflex grease in that last bearing..... what do i do. really dont want to pull motor again.
  6. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    On older sleds (my 2002 MXZ) there is a grease fitting for the main drive shaft buried next to the speedometer cable. I bought a 2010 MXZ XP. Is there a grease fitting for the main track drive shaft? I can not find one if there is. Help!
  7. REV Chassis - Mountain Sleds
    I have post up on Snowest trying to find a fix for the grease getting blown out of my crank bearings from the turbo boost. So if you're familiar with this issue and know of a fix or a potential solution, lets hear it. Basically, all I can come up with is installing a fitting into the case on...
1-7 of 7 Results
Top