Hey there, I’m considering going to look at an 2012 renegade 800r etec with 3300 miles. Never owned an etec before and I am wondering what are some things to look out for specifically. If there are any real differences compared to a carb motor. And, to check runout on the crank, what is, if...

Hey there, I’m considering going to look at an 2012 renegade 800r etec with 3300 miles. Never owned an etec before and I am wondering what are some things to look out for specifically. If there are any real differences compared to a carb motor. And, to check runout on the crank, what is, if...

Has anyone else heard anything about a recall on all 2022 E-Tec sleds? A friend sent me a facebook post about it but I can't seem to find anything about it anywhere else. The post says it's due to "incorrect ECM data entered at factory resulting in possible oil pump failure"

14 800 etec x renegade 6842 Wisconsin and UP miles Studs Auxiliary headlight Very clean sled Always trailered and stored inside shocks and clutch just freshened at Goodwin performance 600 miles ago $6200 obo call bob 309-338-2233 Located in Glasford il L

So I thought I'd post something helpful. It's been a while since I searched this so someone might have beaten me too it. Seems to me that every time I go looking for the part number an automotive pump that works for our sleds it ends up being a goose chase, and I end up scrolling through old...

So I thought I'd post something helpful. It's been a while since I searched this so someone might have beaten me too it. Seems to me that every time I go looking for the part number an automotive pump that works for our sleds it ends up being a goose chase, and I end up scrolling through old...

Anyone happen to have a service manual for this sled? 2011 Back Country 600 etec.

Basically what is happening is after a few seconds at max rpms (~8000) the engine seems to be "cutting out". Rpms drop to ~7400 and then the engine kicks back in. Also, the more times I rev the sled to max rpms the shorter it holds max power before cutting out again. There is also a bit of a...

Hey all, So I recently purchased a 2013 renegade adrenaline 600 etec took it out for my first ride a few weeks ago loved every minute of it!! Next day started sled and could hear a bit of rattling from the primary clutch so I purchased from what I read was oem rebuild kit came with...

I have a 2012 600 etec, started it yesterday (temp about 2 degrees out) and was running great for first couple miles ( have 80 on it this season is all), but after idling for a couple minutes on side of trail check engine light came on. Shut it off and restarted it, light stayed off but noticed...

Was out riding this past weekend when my '13 Backcountry 800 which had a CV tech short block installed about 14 months ago, lost power instantaneously and threw a knock code. I've been down this road before so I pulled the spark plug to find it bent out of shape severely. We towed it home and...

Hi guys. Been having a problem with my '17 850 with the electric start. Its an intermittent issue but sometimes when I hit the start button, I hear a sound from what I think is the electric starter (kind of like a spinning noise) but it does not engage and start the sled. Sometimes it will start...

Hi guys, I need some help with an issue my sled is having. Its a 2009 MXZ 600 etec with almost 20,000km and about 1000km on a full rebuild. First ride of the season on Thursday and about 10 minutes in of rail bed ridding (at a good speed) I feel a brief loss of power but it goes away. 5-10...

Hello All - First time poster, long time reader. I recently acquired a 2015 MXZ 600 H.O. ETEC TNT which was in great condition has around 3900 miles on it. On my first real outing on a lake with a combo of hard pack and fresh snow riding, the sled started exhibiting this weird bogging-down /...

My 2012 summit 800 keeps popping reeds and can't figure out why runs really good but slightly pops on downrevs when your wide open and let off. I'm using spi reed replacements but still should be able to get more then 150 miles out of a set!! Where do I even start to figure out the downrev...

Hey guys I have a 2012 skidoo etec 800 that started out 100 percent un modified then it blew up and I've installed a ptec cylinder in its place drilled oil ports for rave valves and have no problems with it except when I come off the throttle on wide open pulls it slightly backfires on its...

Hi Guys ! I have a 2011 Renegade Backcountry X 800 Etec Engine My Sled starting to yeld some '' Check Key '' codes because de the DESS KEY not mating properly with the Pole., and its getting frustrating. Im new here , i did a lot of search about the Retrofit from DESS to the Newer 2015+...

I am wondering if anyone has experienced what happened to me this week. On Tuesday we got about seven inches of snow in St. Paul, MN so I took my 2017 Renegade X 850 ETEC out of the garage for a quick ride around the park by my house. While going along at about 20 mph, the sled suddenly...

My 2015 MXZ has 2100 miles on it. During my last trip last year, i noticed that the engine would bog once I got up to a 3/4 to full throttle. I could cruise at about 65-70 mph, any throttle to speed up after that, it would bog back down. I started taking my sled apart this month. I found a lot...

2009 MXZ TNT 600 ETEC Original issue was sled shut off during riding and could not get it to start, took it into the dealership and a few weeks of them not knowing what was wrong they call me and tell me it was just the spark plug wires were bad and grounding out. So I picked up the sled and...