Ski-Doo Snowmobiles Forum banner
ecm
1-17 of 17 Results
  1. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    4800 miles, 2016 Renegade Enduro 800R etec, just stopped. Gauges blank. Only thing that works is 12V starter and fuel pump. Pulled apart, 0.9 ohm on each stator coil, no cross resistance, and 20Vac after about half a second of cranking. Fuel pump is working, pulled fuel line. Fuel going into ECM...
  2. REV-GEN 4 - Summit/Freeride/ 850 Turbo
    I posted this in the Summit side too... So, I have a 2019 Summit 850 X. Rode it about 950 miles last season without issue one until it started smoking like we were fogging for mosquitos. It was strange though, start up in the mornings letting it warm up it looked normal with no extra...
  3. MXZX Race Sleds
    Hey All, Heres the long story made short- Bought a 2014 600 RS with the hot start hooked up, worked fine. Brought it home and disconnected pin 10 ecm. Sled worked fine. Synced the carbs, plugged pin 10 back in, reset TPS, unplugged pin 10 again and worked fine. Out playing a week later -...
  4. Race Sled Classifieds
    many 600rs parts for sale, all removed to swap for 800 etec. sled has 2300MI and no damage on any parts. -Complete engine -airbox -carbs -ecm -coolant hoses -coolant bottle -reeds -boots -Trailtanks.net clear tank -10 Gal black tank -complete wiring harness -team secondary -slipper gear
  5. Sled Parts For Sale or Trade
    Item: 600sdi engine, electrical, and parts Category: Sled Year: N/A Location: Mehoopany Pa Price: 50-350 600 sdi complete engine. Bad cylinders and no pistons. Bottom is good. $350 600 sdi bottom end. Needs seals. $250 600 sdi wiring harness, ecm, voltage regulator. $75
  6. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    After getting dunked, we almost had my sled started and the gauges froze and we lost spark. I have read that battery corrosion can cause voltage spikes and fry the ECM. Battery terminals were very corroded. Sprayed stuff on them but didn't take apart. 1. How can I veryify the ECM is fried...
  7. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I thought I would take my 2014 800R ETEC Andrenalen for a little swim. Afterwards we just about had it running after draining all the fluids Etc when the gauges Frozen spark went. There had been some corrosion on the battery that we cleaned up and not by taking it apart apparently this likely...
  8. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    Can anyone tell me were the other end of the poly tube part (# 415080100 item 74) connects to coming out of the ECM (2009 etec 600)? From what I have seen on other sleds this tube heads back towards the center of the sled above the ECM, but don't see anywhere to connect the end with the 90*...
  9. REV-XP / XM Chassis - Mountain Sleds
    Wondering if anyone has a wire diagram for a 2011-12 Summit or Freeride Etec 800. Thanks.
  10. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    I suspect I have a bad ECM. If I buy a used one, with a DESS mated to it, can I just plug it in and it will work? Or do I need to go to a dealer and have them program it to my machine with the BUDS? 2008 MXZX800R.
  11. REV Chassis - Performance and Trail Models
    i have been having problems with my 06 800, first the carb issues then reeds now no spark everything i could check i checked so i broke down and took it to the stealership they pulled the ecm and said there is corroded and broken pins, cost is 700 dollars or so total is gunna be 1000. holy ****...
  12. Sledding - General Discussion
    I thought I would ask this in the general form, since it's not really specific to my sled... Has anyone ever welded on a sled (TIG welding new brackets on heat exchanger) without unplugging the mpem? I'm just wondering how far I need to go to protect the electronics of the sled, before having...
  13. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I put my 2012 600 etec backcountry in for general service and asked them to install an 8" riser. When I got the sled back the handwarmers no longer worked. Returned it to the shop and they told me it was an ECM failure and that my 12 volt would also not work. The dealer said the electrical...
  14. REV Chassis - Mountain Sleds
    Im wondering about having your ECM flashed, could someone enlighten me on this? Does this help performance?
    ecm
  15. Mach Z / Mach 1 / Formula III Triples
    I can't believe it. I lost spark again on my 98 Mach 1,I pulled the brake lever and spark is gone again. I have only ridden it 50 miles since I bought it in November. I patched bare wires to get spark returned the first time, I bought a new black box the second time, Now what will I have to do...
  16. Mach Z RT and MXZ 1000 SDI Models
    I bought a 2007 Machz "x" a couple years back off the original owner. He maintained the heck out of it and had the clutches upgraded and dialed in. He also installed Boyesen rage cages. ( All by Bondi.). I've since done the unifilters etc. One thing owner told me was " u have to install this...
  17. REV Chassis - Mountain Sleds
    riding the other night and my lights seemed to get real bright and then my tach went completely out. i replaced the relay and that is not it, took the tach apart and it is not the trip button being stuck. then finally found the 20 AMP fuse on PTO side was burnt out. I replaced the fuse and then...
1-17 of 17 Results
Top