Search Results for ‘coolant leak’

Hey so i have bought this sled and have been working on it 3 weeks straight now and its just been a money pit so far, just one thing after another. First carb boots with reeds, exhuast expansion chamber, needed the chaincase flushed and seal replaced etc the list goes on. Anyhow got it back...

I have a 2007 800ho powertek. I recently purchased it from someone who had replaced the mag side piston at about 5200 miles. The sled has 5600 miles now and when i bought it, i decided to to a complete rebuild of the motor which included new crankshaft, pistons and rings, gasket kit, etc…. When...

Hey guys looking for some help I’ve got a 2015 skidoo freeride bought it used from a dealer a few months back been I’ve put about 150 miles on. Sled has 7900 miles on it it had a complete top end 2 winters ago from the dealer. So here’s my issue my first ride it was blowing coolant out the...

Have a coolant leak on my sled. Just bought it guy said he did top end 600k ago. Just wondering how deep i should dig. Doesn't fire on clutch side. Has good compression on both sides better on side that isn't working. Good spark etc. Has coolant in muffler and only in side that's not firing...

Took my sled out for a ride this weekend. When I first started my sled after unloaded it off the trailer I thought the idle sounded off. Once the sled warmed up and I took off riding, it seemed to run fine, no issues. After about 30 miles we stopped and got fuel. Rode another 5 miles ish and the...

Can any one tell me what could be happening in this picture

Hi New to this forum but looking for a little advice. I picked up a sled 2007 summit x 800 it had a seized engine the sled only has 800 klm on it. when I took it apart I could see that the piston arm ring pin sprung loose and caught on the exhaust port causing the engine to seize. everything...

I noticed a small leak coming from above the very rear heat exchanger. I am hoping that it is from a clamp. If I take the flap off, will these clamps be exposed?

Got a 99 f3 800 that was leaking coolant into the 3rd cylinder (pull cord side) I replaced the head gasket and seals. The plug was no longer getting wet with the green coolant upon visible inspection. Now I'm loosing coolant somewhere while it sits for days and can't find it. I have no puddles...

First issue is I have a small coolant leak & if I remember correctly I read on here that the 800 PTEK's had a certain area where they tend to leak, but couldn't find anything in my forum search. 2nd less critical issue is the e-start isn't working now that it's all back together. Can anyone...

alright I'm stumped. This is what's going on, my coolant is leaking into only one cylinder on the mag side. I have replaced all top end gaskets including jug/cylinder gaskets. replaced cylinder head and head. I am now thinking it is coming from the bottom. It doesn't leak until the engine...

I have a 2013 GSX SE with an 800 E-Tec engine. It has been pretty cold where I sled and the temps have gotten down to -20*F. I noticed some coolant one morning on the snow beneith the sled. I know my old 800R had some leaks from various positions and I used traditional hose clamps to resolve...