Ski-Doo Snowmobiles Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. General Sledding Discussions
    Looking to swap my 42" front end (Renegade MXZ) for a 38-40 (BC/Freeride) Will my stock shocks fit, or will I have to get the shocks too? thansk! 2017 850 G4
  2. REV Chassis - Performance and Trail Models
    Hi all, New to the page and first time poster. I Have an 03 Rev 800r, after a accident in the beginning of January due to the failure of a lower ball joint, I ended replacing a bunch of parts. Upper and lower a arms, steering rods, that I found on Facebook marketplace. I bought new upper ball...
  3. General Sledding Discussions
    Where can i find a source for replacement upper and lower a arm for Polaris fusion?
  4. REV-XP/XS Chassis: Renegades/Freeride/Backcountry
    I have a 2014 freeride that I find myself needing a wider front due to the riding we do. Do anyone know if you can just put the wider a arms on it and use existing shocks or are the shock different lengths on say an xrs. Thought there was an a arm kit ski doo offered but all I see is the whole...
  5. REV-XR/XS Chassis: 4-TEC 1200 Perf. & Trail Models
    MShk01 Hardware Kit This Kit will be at a great advantage so you can remove the skid plate without drilling out those nasty rivets Tool included for 6 bottom inserts The front four are custom designed by myself for a flush fit Access to a inch pound torque wrench is recommended for...
  6. REV Chassis - Performance and Trail Models
    Here is a typical swing arm bushing that damaged the tunnel on this sled Its a 2004 MXZX Renegade 600HO SDI with a SC10 III skid The only 2 moveable joints that are not greased damaged this tunnel If they were this probably would not have happened This pic shows the worn out axle and bushing...
  7. REV-XP/XS Chassis: Perf. Trail 120-129 Inch Models
    When i started this project in late December 0f 2012 it was only Greasable Control Arm Bushings I had a lot of inquiries regarding rear suspension bushing kits Well I redesigned the Swing Arm Bushings and Aluminum axle that secures the arm to the rails and tunnel I manufacture the complete kit...
1-7 of 7 Results
Top