Ski-Doo Snowmobiles Forum banner
1980
1-11 of 11 Results
  1. Vintage Ski Doo's
    I am looking for 440 cylinders, jugs, pistons and head for 1979 or 1980 Ski blizzard Also the carbs . Thanks in advance 715-410-1326
  2. Vintage Classifieds
    Looking for some 440 jugs, pistons and head from a 1979 or 1980 9500 Blizzard. Worse case scenario some 340 cylinders set would get it running again. Also need 1978 steal primary clutch. 38 carbs for a 440 also. 715-410-1326
  3. Vintage Ski Doo's
    Hey out there, smarter people than me, I was hoping this wasn't the case, but after being a good little boy and doing some reading in the forums here I've come to the conclusion that my crank bearing is shot. When I had the engine out i didn't notice any grinding or wiggle in the shaft but I...
  4. Vintage Ski Doo's
    I have a type 454 rotax, blew one side, bunch of scoring, 30psi compression, going to bore the cyl out and put in new piston and ring. It is already done .010 over, so where can I find .020 oversized pistons and rings? Thx
  5. Vintage Classifieds
    Looking for a good citation ss hood that will fit a 1980 model. Would prefer the yellow. Thanks
  6. Vintage Ski Doo's
    Picked up my first restore project. Not real sure yet if a restore is feasible or part out is in order. Goods The sled is 100% original. Under 2000 miles. The belly pan is not dented, a little surface rust, but still in good shape. Everything is there. The track is in fair condition, can't see...
  7. Vintage Ski Doo's
    Hey there doo'ers. My area is finally supposed to get some snow tomorrow, a predicted 20 cm. My sled is ready to go, except for the 34 year old chaincase oil that's in it right now. It's a 1980 ski doo everest 500, not the Everest l/c electro, just the good ole rotax 503 with a single carb, no...
  8. mileage

    This sled wasn't used for nearly 20 years, and was stored covered, but outside, and the track was on the ground. It had a busted slider, a seized hydraulic shock, and bearings with next to no grease in them. I got the suspension out, repacked all the bearings with new grease, put in a shock and slid
  9. Vintage Ski Doo's
    Hi there guys, need some help. I need a carburetor boot (after carburetor, connects to carburetor and intake manifold). I have a single mikuni vm-36 carb, and the boot has cracked and dried up, causing a split. I want to get a new boot. I ordered one, part numbe 7-100-13, and it is listed under...
  10. Vintage Ski Doo's
    Hi there dooers. Ive got a 1980 Bombardier Ski-Doo Everest 500, 695 original imperial miles, the torque reaction slide suspension is almost ll stock. All I've done is repack the bearings with new grease and replace a busted slider and shock. One of the bearings went to crap, and I need a new...
  11. Vintage Ski Doo's
    I recentally did a cdi conversion on a 1980 Citation 4500 and it bolted right on. And runs great now however I do need some help with wiring... I have the 2 wires going to the cdi, and then 2 yellows and a black stray. Now the question is! How do I hook up my lights/key/kill switch etc? To the...
1-11 of 11 Results
Top