will74 - Viewing Profile: Posts - DOOTalk Forums

Jump to content

 






will74

Member Since 02 Oct 2005
Offline Last Active Apr 03 2021 01:36 PM
-----

Posts I've Made

In Topic: 99 mach z motor into a 99 Formula 3 700 chassis help

29 January 2021 - 03:26 PM

Bought crank shop clutch alignment tool. Mag side mounts ended up being very close. Opened up one hole. Had to drill and relocate pto side motor strap to get mounts to line up.

In Topic: 99 mach z motor into a 99 Formula 3 700 chassis help

24 January 2021 - 08:29 PM

should have mentioned this in my original post.  I have the following from the mach Z that i plan on using in the formula 3 chassis::

carbs

air box

voltage reg

cdi

harness

triple pipes

muffler

clutches

fuel pump

jackshaft if needed


In Topic: 99 mach z motor into a 99 Formula 3 700 chassis help

24 January 2021 - 06:37 PM

The engine support plates and mounts are the appear to be the same part #.   Might try The Crank Shop tomorrow to see if the have something to offset the motor mounts.  


In Topic: Hurricane 175 Studs vs. Screw-in

23 January 2020 - 11:00 AM

Running igrip screw in studs on my 20 Freeride with hurricane track. 3rd sled I've put these on. So far so good. Stay away from center of track to avoid tunnel protector. Helps out in icy corners and parking lots. Not the same traction wise as conventional studs buy not the track to buy if running hard pack and ice.

In Topic: 2013 600rs pro open mod race sled seat

14 January 2020 - 08:42 PM

Interested. Sent you a pm. Will this fit a 10 gal tank?