cdm 800 etec - Viewing Profile: Posts - DOOTalk Forums

Jump to content

 






cdm 800 etec

Member Since 18 Feb 2011
Offline Last Active Apr 11 2021 02:01 PM
-----

Posts I've Made

In Topic: FPP 9.5:1 Wiseco pistons

21 February 2021 - 08:03 PM

still available?


In Topic: GTX3076 Gen 2 / with Tial V-Band .63 housing

19 February 2021 - 10:16 PM

Is this still available?

In Topic: Precision Sports Intercooler

23 September 2020 - 06:04 PM

Sent you pm

In Topic: XS Clutch clearance issue with STM or TAPP

05 April 2020 - 06:56 PM

What spring was in your PB. Skidoo or cvtech. The skidoo springs will bind in them and not allow them to shift causing slip.

Not sure it was solid black and came with the sled

In Topic: XS Clutch clearance issue with STM or TAPP

05 April 2020 - 08:10 AM

I would check your offset first. Even before you pull your motor so you can know where your at and where you end up. I also have to ask what belts you were running and what primary clutch?

As for the solid motor mounts I set mine .5 mm taper on the factory qrs shaft but with the doodr shaft there is a little play in the splines so it measures straight with that

I was running dayco 5034 belts then switched to an ultimate 821 with better results. I was running a pb80 primary and stock secondary