Hey so this spring when i was pulling my engine, I found some grey gunk settled at the bottom of the engine, as well as in coolant resevoir. Not sure if PO put oil in coolant by accident or a gasket was gone. Anyways i sent out my case for a good cleaning and a new crank, but now i need to flush my exchangers. Can i do this with them in the sled or should i pull them and soak em in vinegar or acid? Any advice on how i should go about this would be very helpful.
Thanks
Jordan
Flushing Heat exchanger
Started By Jordingo, Jul 27 2014 09:47 AM
2 replies to this topic
#2
westrip
-
- Members
-
- 377 posts
Advanced Member
- Gender:Male
- Location:Fuzzy Body Part - Fernie, BC
- Interests:Sleds, Dual Sport Bikes, Street Bikes, Mountain Bikes, White Water Rafting, Kayaking, Canoeing, Hiking, Rock Climbing, Skiing, Snowboard, Mountaineering, Carpentry, Mechanics, Music, Travel
- Sled:14 Summit X 174-3"2007 Summit XRS800R159
Posted 27 July 2014 - 10:26 PM
I would avoid any cleaning agents and just flush with your garden hose outside. If it doesn't come out then it never will.
- Highmarkdooman likes this
#3
Jordingo
-
- Members
-
- 107 posts
Advanced Member
- Sled:07 summit 800r
Posted 28 July 2014 - 04:58 PM
alrighty thank you. i will try it out
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
