2011 Summit X 800r Etec 146 primary clutch rebuild - REV-XP / XM Chassis - Mountain Sleds - DOOTalk Forums

Jump to content

 






Photo

2011 Summit X 800r Etec 146 primary clutch rebuild


  • Please log in to reply
4 replies to this topic

#1 Jonnywire

Jonnywire

    Newbie

  • Members
  • Pip
  • 8 posts
  • Sled:2011 Ski Doo Summit X 800R Etec

Posted 10 April 2021 - 02:07 AM

I have a 2011 Summit X 800r Etec 146 with the rev xp chassis. I got my primary clutch out of the sled but I cannot get the sliding half off the shaft. I have tried both suspending it in place and using a 4x4 like a mallet on the puller head and dropping it onto a piece of wood and it will not budge. Do I have to have it off the shaft to do the rebuild. Any other suggestions for getting the sliding half off if so?

Edited by Jonnywire, 10 April 2021 - 02:17 AM.


#2 ajellis12

ajellis12

    Advanced Member

  • Members
  • PipPipPip
  • 36 posts
  • Gender:Male
  • Location:Jay, Maine
  • Sled:09 Summit xm 800 ptek 154”

Posted 10 April 2021 - 02:46 PM

You need to either use the bolt or puller and thread it in a little ways then just give a good tap and they will come apart no problem. Make sure that you mark it so you can line everything up the way it was to keep the balance.

#3 Jonnywire

Jonnywire

    Newbie

  • Members
  • Pip
  • 8 posts
  • Sled:2011 Ski Doo Summit X 800R Etec

Posted 10 April 2021 - 04:11 PM

Yeah, that is what I tried. No luck, won’t budge.

#4 Dynamo^Joe

Dynamo^Joe

    Metalhead

  • Sponsors
  • 9085 posts
  • Gender:Male
  • Location:Thunder Bay
  • Interests:SUMMIT platform SkiDoo's. Being a student of the TRA clutches.
  • Sled:850, 154, 3" - 13, 872 custom 120, 3"

Posted 10 April 2021 - 08:57 PM

Ive had ones stuck on enough that I went out to the street and the concrete curb.  then down on knees and held the clutch over my head and drove the puller head onto the curb - it come apart.   Need to get angry at it.  I show in a few clutch kit install videos on youtube, on how to do it.



#5 Jonnywire

Jonnywire

    Newbie

  • Members
  • Pip
  • 8 posts
  • Sled:2011 Ski Doo Summit X 800R Etec

Posted 11 April 2021 - 06:25 PM

Thanks Dynamo Joe. I checked out some of your you tube videos too, you explain things well in them, good info.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users