Edited by doo 67, 26 October 2020 - 03:52 PM.
chaincase bearing puller
Posted 26 October 2020 - 03:47 PM
Posted 26 October 2020 - 10:53 PM
Posted 27 October 2020 - 07:10 AM
I bought the lower bearing puller / pusher based on the advice from a similar thread. And yes. made the whole thing very easy. Installing the new seal - I should have pulled the seal to a more solid bottom as the steel lip was ever so slightly proud. I did store the bearing and the seal in the freezer over night before installing and have no idea if this was a help or not. By the time I got everything lined up, the bearing was probably not that cold. But it didn't hurt. I also put some really thick grease on the bore before installing the bearing and the seal.
For the upper, at first I went cheap. Got the seal and bearing out easily with some plumbing parts, (see below for the seal parts) and some ground down sockets for the bearing. The seal went in easily with a different set of sockets but the bearing kept going in out of square. I was reluctant to hit the bearing with a hammer or "tap it in" as some suggested. I ended up getting the upper pusher / puller "used" on the web for about $50. (paid full price for the lower :-( No uppers were available used. With the factory pusher, pressing in the upper bearing went in very quick and easy. The different plumbing parts and the different sockets probably ran close to $30.
I'll post some of the pictures of the plumbing approach.
Are you close to Waterford, Michigan? If you are in driving distance, you could borrow them.
Posted 27 October 2020 - 07:56 AM
Posted 27 October 2020 - 09:16 AM
Here are the diameters and lengths of the pullers if folks want to try to cobble something together.
On the Lower, the first number is the diameter and the second is the length of that section.
Posted 27 October 2020 - 09:18 AM
The pictures in the prior post are for the Upper Puller.
In this post, the first is the Upper and the second is the Lower.
Posted 27 October 2020 - 09:20 AM
Posted 27 October 2020 - 09:40 AM
Wondering what the part numbers are for all of them?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users