2016 Freeride 12v plug - REV-XP / XM Chassis - Mountain Sleds - DOOTalk Forums

Jump to content

 






Photo

2016 Freeride 12v plug


  • Please log in to reply
3 replies to this topic

#1 s__whelan

s__whelan

    Newbie

  • Members
  • Pip
  • 3 posts
  • Sled:2016 Freeride 154"

Posted 30 August 2020 - 09:44 AM

Quick question here guys, I picked up a 2016 Freeride a couple of weeks ago. It has the BRP Garmin mount for the Montana GPS. My question is does this mount use the same plug for the 12V plug from BRP? If so is there a splitter I can buy? I want to use my garmin 64S and need the cig 12V plug. Thanks 



#2 Daag44

Daag44

    Advanced Member

  • DOOCrew
  • 25127 posts
  • Gender:Male
  • Location:South Shore, Quebec
  • Interests:1973 Olympic
  • Sled:2007 1000 SDI

Posted 01 September 2020 - 01:12 AM

The dealer has a splitter available.


Air/Fuel Ratio for two and four strokes
Air/Fuel Ratio for 1200 with boost
Air/Fuel Ratio is measured through emissions
Wideband and EGT
Wideband readings of Air/Fuel Ratio on a two stroke
600 SDI MY2004 Lean/Hot spot running 6900-7000 rpm @ 40-45% Throttle Opening
800R Cranking Compression
800R Oil Injection / Premix combo
800R Turbo?
900 ACE Turbo - muffler turning red hot
1200 4-TEC Mapping
1200 4-TEC MY 2009 to 2011 Fuel Line issues that could cause a fire
Batteries
Belt Blowers: Overview of UPMICHIGANDER's experience
BUDS 3.3.0 won't connect to SDI
BUDS not connecting to HO or SDI - Try a CanDoo
CVT efficiency - BlueMax
Deep snow intake for XP chassis
Diagnoses
E-TEC 600HO Clutching
E-TEC Oil Pump
E-TEC Dial-A-Jet
E-TEC Engine Management
E-TEC Stator fault codes P1562 or P1563
E-TEC Capacitor Charge Hold Test and Residual Voltage Test
Fuel Issues: Could new Ester type oxygenated additives be deteriorating the Fuel Sender Grommet?
Fuel pump and regulator replacement for ACE, E-TEC and SDI
Gasoline quality and storage
Bad Gas for a Two Stroke - Is it a Myth ?
G4 Clutch Alignment, Engine Movement, Sheave Runout and Clutching
GNR CVT Alignment for the G4
Grip N Rip Clutch Alignment testing
G4 850 Throttle Jerkiness solved with clutching
G4 850 Snappy throttle/clutch engagement
G4 850 pDrive tech - A question of Engineering
G4 850 Tuned Pipe @ 12.6 lbs and Muffler @ 15.4 lbs vs 800R and 800RE muffler weight
Pictures - How to resize and upload to DooTalk
Pipe Pressure testing on a dyno
Pipe Pressure testing from LRD (#1) and (#2)
Pipe Pressure testing results from BRP
Oil versus Fuel consumption
Power at the Crankshaft vs Track - BlueMax
Power Curves: 600 HOE (E-TEC)
Power Curves: 600 vs 800 vs 850 vs 1000 vs 1200
Power Curves: 1000 vs 800 vs 600
Power curves: 800RE 2010.5 to 2016 vs 2016.5 850
Quebec/NY State border crossing
REV Gen1 Gauge Display stuck on "SCALE"
REV Gen1 Volt and Temp Gauge install
REV Gen1 electrical connectors for sensors and MPEM (Multi Purpose Engine Module)
Shortblock or Rebuild?
Ski-Doo Snowmobile Tech Training
Stator testing for E-TEC using a T harness/Bridge
Stator testing for 1200 4-TEC
Stator replacement for a 1200 4-TEC
Suspension Adjustment
Triples - Coolant Pump Assembly
Y-Pipe bolts loosening fix


#3 Daag44

Daag44

    Advanced Member

  • DOOCrew
  • 25127 posts
  • Gender:Male
  • Location:South Shore, Quebec
  • Interests:1973 Olympic
  • Sled:2007 1000 SDI

Posted 01 September 2020 - 01:14 AM

I think that you will find the GPS forum helpful.
 

GPS Talk
A place to talk about GPS equipment and all the stuff that goes along with it.


Air/Fuel Ratio for two and four strokes
Air/Fuel Ratio for 1200 with boost
Air/Fuel Ratio is measured through emissions
Wideband and EGT
Wideband readings of Air/Fuel Ratio on a two stroke
600 SDI MY2004 Lean/Hot spot running 6900-7000 rpm @ 40-45% Throttle Opening
800R Cranking Compression
800R Oil Injection / Premix combo
800R Turbo?
900 ACE Turbo - muffler turning red hot
1200 4-TEC Mapping
1200 4-TEC MY 2009 to 2011 Fuel Line issues that could cause a fire
Batteries
Belt Blowers: Overview of UPMICHIGANDER's experience
BUDS 3.3.0 won't connect to SDI
BUDS not connecting to HO or SDI - Try a CanDoo
CVT efficiency - BlueMax
Deep snow intake for XP chassis
Diagnoses
E-TEC 600HO Clutching
E-TEC Oil Pump
E-TEC Dial-A-Jet
E-TEC Engine Management
E-TEC Stator fault codes P1562 or P1563
E-TEC Capacitor Charge Hold Test and Residual Voltage Test
Fuel Issues: Could new Ester type oxygenated additives be deteriorating the Fuel Sender Grommet?
Fuel pump and regulator replacement for ACE, E-TEC and SDI
Gasoline quality and storage
Bad Gas for a Two Stroke - Is it a Myth ?
G4 Clutch Alignment, Engine Movement, Sheave Runout and Clutching
GNR CVT Alignment for the G4
Grip N Rip Clutch Alignment testing
G4 850 Throttle Jerkiness solved with clutching
G4 850 Snappy throttle/clutch engagement
G4 850 pDrive tech - A question of Engineering
G4 850 Tuned Pipe @ 12.6 lbs and Muffler @ 15.4 lbs vs 800R and 800RE muffler weight
Pictures - How to resize and upload to DooTalk
Pipe Pressure testing on a dyno
Pipe Pressure testing from LRD (#1) and (#2)
Pipe Pressure testing results from BRP
Oil versus Fuel consumption
Power at the Crankshaft vs Track - BlueMax
Power Curves: 600 HOE (E-TEC)
Power Curves: 600 vs 800 vs 850 vs 1000 vs 1200
Power Curves: 1000 vs 800 vs 600
Power curves: 800RE 2010.5 to 2016 vs 2016.5 850
Quebec/NY State border crossing
REV Gen1 Gauge Display stuck on "SCALE"
REV Gen1 Volt and Temp Gauge install
REV Gen1 electrical connectors for sensors and MPEM (Multi Purpose Engine Module)
Shortblock or Rebuild?
Ski-Doo Snowmobile Tech Training
Stator testing for E-TEC using a T harness/Bridge
Stator testing for 1200 4-TEC
Stator replacement for a 1200 4-TEC
Suspension Adjustment
Triples - Coolant Pump Assembly
Y-Pipe bolts loosening fix


#4 wmoater

wmoater

    Advanced Member

  • Members
  • PipPipPip
  • 920 posts
  • Gender:Male
  • Sled:2015-1200 gade x/ 2010-600 TNT

Posted 01 September 2020 - 10:35 AM

Don’t quote me but there should be a plug already in your front dash. Open the glove door and there should be one. Take the lights off and trim off and simply bug into the back. You don’t have to have a splitter. You can buy the two pieces from Mouser. I ca’t remember if you have the male or female. I believe you need the female 2 pieces only. Pretty easy. I know the 17’s had them not sure if the 16’s did in the glove box.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users