2004 summit 800HO mpem programming - REV Chassis - Performance and Trail Models - DOOTalk Forums

Jump to content

 






Photo

2004 summit 800HO mpem programming


  • Please log in to reply
1 reply to this topic

#1 skidoowyo181

skidoowyo181

    Newbie

  • Members
  • Pip
  • 2 posts
  • Sled:2004summit

Posted 22 April 2020 - 04:57 PM

I have a 2004 800ho summit and took it to the dealer to have a dess key programmed. seemed like there Buds wont work on it. wouldn't connect to the mpem. would a candoo programmer work? I would invest in one if anybody knows for sure it will work on this 2004 sled?



#2 Daag44

Daag44

    Advanced Member

  • DOOCrew
  • 26542 posts
  • Gender:Male
  • Location:South Shore, Quebec
  • Interests:1973 Olympic
  • Sled:2007 1000 SDI

Posted 23 April 2020 - 06:16 AM

It should work with a CanDoo. I have had the same problem with an 07 SDI at the dealer with BUDS, but the techs had kept different versions on their computer and found one that worked. You can call or email CanDoo for this question as they have the seen the same problem with BUDS. One SDI owner on DooTalk dealt with the same problem with his SDI to get it connected at the dealer. They wanted to order a new ECM for it. He ended-up bringing his sled to someone with a CanDoo to get it fixed. Fortunately I found the thread on DooTalk that shows the full story. The link will go to the post that shows the dealer had ordered a new ECM and VRR that was not needed. At that time I did call CanDoo pro to confirm, but you should as well for your sled as I can't guarantee anything other than the experiences I have had.
 
 

Anyone an expert on the 600SDI engines?
Started By FlavorDave, Mar 26 2019 01:57 PM
https://www.dootalk....5#entry22837133


Air/Fuel Ratio for two and four strokes
Air/Fuel Ratio for 1200 with boost
Air/Fuel Ratio is measured through emissions
Wideband and EGT
Wideband readings of Air/Fuel Ratio on a two stroke
600 SDI MY2004 Lean/Hot spot running 6900-7000 rpm @ 40-45% Throttle Opening
800R Cranking Compression
800R Oil Injection / Premix combo
800R Turbo?
850 Center Oil line for coolant pump melted
850 Main Oil line caught fire #1 and #2
900 ACE Turbo - muffler turning red hot
1200 4-TEC Mapping
1200 4-TEC MY 2009 to 2011 Fuel Line issues that could cause a fire
Batteries
Belt Blowers: Overview of UPMICHIGANDER's and Ronn's experience
BUDS 3.3.0 won't connect to SDI
BUDS not connecting to HO or SDI - Try a CanDoo
CVT efficiency - BlueMax
Deep snow intake for XP chassis
Diagnoses of a failed ECM
Electrical - Solder vs Crimp
Electrical Diagram for Fanners on page 3
E-TEC 600HO Clutching
E-TEC Oil Pump
E-TEC Dial-A-Jet
E-TEC Electric Start troubleshooting
E-TEC Engine Management
E-TEC eRAVE position code recurring
E-TEC Stator fault codes P1562 or P1563
E-TEC Capacitor Charge Hold Test and Residual Voltage Test
E-TEC Voltage Rectifier Regulator troubleshooting
E-TEC Power Fades are not normal and can be fixed
Fuel Issues: Could new Ester type oxygenated additives be deteriorating the Fuel Sender Grommet?
Fuel pump and regulator replacement for ACE, E-TEC and SDI
Gasoline quality and storage
Bad Gas for a Two Stroke - Is it a Myth ?
G4 Clutch Alignment, Engine Movement, Sheave Runout and Clutching
GNR CVT Alignment for the G4
Grip N Rip Clutch Alignment testing
G4 850 Throttle Jerkiness solved with clutching
G4 850 Snappy throttle/clutch engagement
G4 850 pDrive tech - A question of Engineering
G4 Steering
G4 850 Tuned Pipe @ 12.6 lbs and Muffler @ 15.4 lbs vs 800R and 800RE muffler weight
Longevity - 800R E-TEC 
Mikuni o-ring for carb float assembly - Arctic Cat part# 6505-875 or from Amazon and eBay
Muffler Red Hot
Oil versus Fuel consumption
Pictures - How to resize and upload to DooTalk
Pictures - How to post with the correct orientation
Pipe Pressure testing on a dyno
Pipe Pressure testing from LRD (#1) and (#2)
Pipe Pressure testing results from BRP
Power Loss - How to diagnose in the field
Power at the Crankshaft vs Track - BlueMax
Power Curves: 600 HOE (E-TEC)
Power Curves: 600 vs 800 vs 850 vs 1000 vs 1200
Power Curves: 1000 vs 800 vs 600
Power curves: 800RE 2010.5 to 2016 vs 2016.5 850
Quebec/NY State border crossing
REV Gen1 Gauge Display stuck on "SCALE"
REV Gen1 Volt and Temp Gauge install
REV Gen1 electrical connectors for sensors and MPEM (Multi Purpose Engine Module)
Seafoam for E-TEC injectors
Shortblock or Rebuild?
Ski-Doo Snowmobile Tech Training
Spark Plugs cracked
Stator testing for E-TEC using a T harness/Bridge
Stator testing for 1200 4-TEC
Stator Removal on page 3
Stator replacement for a 1200 4-TEC
Suspension Adjustment
Triples - Coolant Pump Assembly
Y-Pipe bolts loosening fix





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users