etec oil pump offset - REV-GEN 4 - MXZ Performance Trail 129/ Renegade 137 - DOOTalk Forums

Jump to content

 






Photo

etec oil pump offset

oil consumption oil pig oil pump oil pump setting buds candoopro

  • Please log in to reply
1 reply to this topic

#1 351c

351c

    Advanced Member

  • Members
  • PipPipPip
  • 1388 posts
  • Gender:Male
  • Location:carp canada
  • Interests:sleds, atvs, camping, downhill skiing, gas powered stuff,
  • Sled:2018 850xrs renegade

Posted 06 May 2018 - 09:44 AM

Can anyone verify that lowering the oil pump offset using candoopro or buds will reduce oil consumption?

Its what I've always thought, but someone posted that a higher number = lower oil usage?

I'm about 30:1 right now and just upgraded the licenese on my candoopro to work on my 2018



#2 Daag44

Daag44

    Advanced Member

  • DOOCrew
  • 27237 posts
  • Gender:Male
  • Location:South Shore, Quebec
  • Interests:1973 Olympic
  • Sled:2007 1000 SDI

Posted 06 May 2018 - 03:33 PM

The opposite is true as far that I know.

 

Lower the number = more oil.

 

An experience BRP tech at your local dealer should know this like the palm of their hand, so maybe check with them first.


Air/Fuel Ratio for two and four strokes
Air/Fuel Ratio for 1200 with boost
Air/Fuel Ratio is measured through emissions
Wideband and EGT
Wideband readings of Air/Fuel Ratio on a two stroke
600 SDI MY2004 Lean/Hot spot running 6900-7000 rpm @ 40-45% Throttle Opening
800R Cranking Compression
800R Oil Injection / Premix combo
800R P-TEK Electrical Troubleshooting #1 and #2 
800R Turbo
850 Center Oil line for coolant pump melted
850 Main Oil line caught fire #1 and #2
900 ACE Turbo - muffler turning red hot
1200 4-TEC Mapping
1200 4-TEC MY 2009 to 2011 Fuel Line issues that could cause a fire
Batteries
Belt Blowers: Overview of UPMICHIGANDER's and Ronn's experience
BUDS 3.3.0 won't connect to SDI
BUDS not connecting to HO or SDI - Try a CanDoo
CVT efficiency - BlueMax
Deep snow intake for XP chassis
Electrical - Diagnoses of a failed ECM
Electrical - 30A Battery Charging Fuse Socket Diagnoses and Relay
Electrical - Relay Coil Wine
Electrical - Relay Testing
Electrical - Battery Charging Relay Diagnostic 
Electrical - Troubleshooting with BRP video 
Electrical - Solder vs Crimp
Electrical - Diagram for Fanners on page 3
Engine Break-In 
Engine Weight 
E-TEC 600HO Clutching
E-TEC Oil Pump
E-TEC Dial-A-Jet
E-TEC Electric Start troubleshooting
E-TEC Engine Management
E-TEC eRAVE position code recurring
E-TEC Stator fault codes P1562 or P1563
E-TEC Capacitor Charge Hold Test and Residual Voltage Test
E-TEC Voltage Rectifier Regulator troubleshooting
E-TEC Power Fades are not normal and can be fixed
Fuel Issues: Could new Ester type oxygenated additives be deteriorating the Fuel Sender Grommet?
Fuel pump and regulator replacement for ACE, E-TEC and SDI
Gasoline quality and storage
Bad Gas for a Two Stroke - Is it a Myth ?
GNR CVT Alignment for the G4
Grip N Rip Clutch Alignment testing
G4 Clutch Alignment, Engine Movement, Sheave Runout and Clutching
G4 850 Throttle Jerkiness solved with clutching
G4 850 Snappy throttle/clutch engagement
G4 850 pDrive tech - A question of Engineering
G4 Steering
G4 850 Tuned Pipe @ 12.6 lbs and Muffler @ 15.4 lbs vs 800R and 800RE muffler weight
Longevity - 800R E-TEC 
Mikuni o-ring for carb float assembly - Arctic Cat part# 6505-875 or from Amazon and eBay
Muffler Red Hot
Off-trail riding for flatlanders
Oil versus Fuel consumption
Pictures - How to resize and upload to DooTalk
Pictures - How to post with the correct orientation
Pipe Pressure testing on a dyno
Pipe Pressure testing from LRD (#1) and (#2)
Pipe Pressure testing results from BRP
Power Loss - How to diagnose in the field
Power at the Crankshaft vs Track - BlueMax
Power Curves: 600 HOE (E-TEC)
Power Curves: 600 vs 800 vs 850 vs 1000 vs 1200
Power Curves: 1000 vs 800 vs 600
Power curves: 800RE 2010.5 to 2016 vs 2016.5 850
Quebec/NY State border crossing
REV Gen1 Gauge Display stuck on "SCALE"
REV Gen1 Volt and Temp Gauge install
REV Gen1 electrical connectors for sensors and MPEM (Multi Purpose Engine Module)
Seafoam for E-TEC injectors
Shortblock or Rebuild?
Ski-Doo Snowmobile Tech Training
Spark Plugs cracked
Squish - The limit
Squish - A discussion on head design
Stator and Relay Diagnostic 
Stator testing for E-TEC using a T harness/Bridge
Stator testing for 1200 4-TEC
Stator Removal on page 3
Stator replacement for a 1200 4-TEC
Suspension Adjustment
Triples - Coolant Pump Assembly
Y-Pipe bolts loosening fix





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users