Jump to content

 





Smitty600

Member Since 09 Nov 2010
Offline Last Active May 06 2013 05:18 AM
-----

Topics I've Started

sunk sled what to do

06 May 2013 - 05:20 AM

hi guys so I did the dumb thing and skipped water all day then the last run going to slow the belt got wet needless to say I went down to just below the headlights in water so my question to you guys is what do I drain and whats fine to leave I put it on its side and drained as much as I could pulled it over for ever then took it for a ride everything seems to work fine but should I drain


tailwalking my 2010 600 mxz tnt

31 March 2013 - 11:54 AM


primary clutch sliding sheave has a little play

21 January 2013 - 05:40 PM

hi the sliding half of my primary has a little back and forth play like less than 1/16'' so i cant rly take a video of it i was just wondering if this is normal or ok machine has 1900 miles on it


2010 mxz tnt 600 lsoes rpm in deep snow

19 January 2013 - 06:44 PM

i changed the track to a 1.75'' lug and gearing to 21/49 i was just wondering why i lose some rpm in deep snow like it drops to 7700 rpm in deep snow but on the trail with powder or if u play around for abit in the deep stuff its 8000 any ideas? or is if fine thanks


see through y pipe

30 December 2012 - 07:33 PM

hi everyone smoked a few trees so i have alot of the front end apart and i noticed my y pipe on the engine side can see a tiny bit of light threw checked with a flash light its pretty small hair width id say about 1/2 inch long im jsut wondering if its ok to run liek this or what im not sure how long its been liek this but i jsut checked my plugs and they are cardboard brown, also i was wondering about sliders when to replace mine id say at the smallest point theres about 1/8'' b4 the wear line jsut wonderin if they would be fine for this season or what thanks