Jump to content

 





mxzx700trygstadmod

Member Since 24 Oct 2006
Offline Last Active May 20 2013 12:24 PM
-----

Posts I've Made

In Topic: 03, 800 DPM won't run

10 May 2013 - 02:50 AM

Have you checked your fuel valves to your carbs, where you take the floats out and look in there. I had something in mine and it kept the valve open, flooding the engine. With a full tank it would siphon out and you could smell the gas. But maybe in your case it may be clogged. The viton tip would not plug the fuel inlet to the bowl because of some hard gum like deposit. I went through that episode with reruns this last sled season.

In Topic: Bristol Bay AK, last ice fishing trip

04 May 2013 - 02:29 AM

Good to see your still riding & having fun. Sockeye season right around the corner

. I am now putting my sled away and hope to knock down some waterfowl here for the next month. Launching the boat very soon. But yes, it was fun. The lowlands here are now showing a lot of ground. That means gravel travel here in town, but there still is a lot if snow in the mountain valleys.

In Topic: Trailer Pic :P

04 May 2013 - 01:37 AM

found both of these online

. Is that a Lexus?

In Topic: is it possible to detune race port to run premium gas

04 May 2013 - 01:28 AM

I run a 2008 600SDI single pipe and race dept hot trail curve, Trygstad ported 700 cylinders, 8 hole base gasket, stock 700 head machined .018 with .065 squish on a 2010 RS 600 bottom end.

. You must like that setup, I've seen other post with you raving about it. I'd like to ditch the twins and run a single. I didn't know what I was getting into at the time. Now I do. And want a single pipe.

In Topic: Bristol Bay AK, last ice fishing trip

03 May 2013 - 10:38 PM

What was the Ruger for? Is that their 44 Mag. version? A little bear therapy........

. 10/22 wolverine and otter patrol. My buddy had a 270 for bear protection had we needed it. They are coming out now.