Jump to content

 




  2. → Viewing Profile: Topics: MzI

MzI

Member Since 15 Jul 2006
Offline Last Active Today, 10:15 AM
*****

Topics I've Started

XRS 4th wheel kit and rear axle

23 December 2012 - 09:00 PM

SOLD!!

I have a 4th wheel axle setup off a 11 XRS.  Axle, all spacers plastic blocks rings etc, and 1 (one) wheel are included.  Other three wheels are shot, can be included if you want them, otherwise they will end up in the garbage.  I am switching to a RS rear axle and wheels so no longer need this setup.  $75 shipped in the US, Canada a bit more.

Attached File  2012-12-23_19-43-20_277.jpg   27K   5 downloads

sc5 120 rear skid complete

18 December 2012 - 05:54 PM

SOLD


Selling my sc5 out of my 09 MxZ Trail.  ~3000 miles on the skid.  RS Rail bracing.  Old style/RS rear arm, better for big bumps and flying through the air.  Has brand new Motion control shocks.  Took em out when I bought the sled and swapped in Zbroz X1s, which are not included.  All wheels in good condition.  RS support rods under the rear rear shock.  $400 shipped in the US, Canada actual shipping.  Paypal add 3%.

Backers and studs, used and new

28 November 2012 - 12:00 PM

Some new some used backers and some new studs. Paypal add 3%. Prices do not included shipping. Will ship USPS flat rate.

New

Woody's 7mm 1.2" Push Through Chisels, qty 16, $16
Posted Image

Woody's 7mm Angled Double Backers, qty 88, $90
Posted Image

Snow Studs 5/16" Double Backer, qty 132, $100
Posted Image

Like New

5/16" Double Bender Plates, qty 36, $35
Posted Image

Woody's 7mm Triple Point Double Bender Plate, qty 24, $35
Posted Image

Used

Woody's 5/16" Double Backer, qty 17, $9
Posted Image

Woody's 5/16" Angled Double Backer, qty 48, $36
Posted Image

Woody's 5/16" Angled Single Backer, qty 19, $8
Posted Image

Stud Boy 5/16" Single Backer, qty 27, $8
Posted Image

Stud Boy 5/16" Double Backer, qty 21, $11
Posted Image

Race Sled Clutch Alignment

20 November 2012 - 12:36 PM

I had a thought about the clutch alignment on my race sled as I am getting ready to realign the motor to switch back to a Formula Secondary from a RER secondary.  On the X/Y specs it states 1.5 mm to compensate for motor twist due to torque and rubber motor mounts.  Now in my race sled, I have solid motor mounts and a torque arm which equates to no motor twist.  Wouldn't it be better to have a X/Y of 0 as the primary would always stay in the same location in relation to the secondary versus a motor with rubber motor mounts that rotates into proper location under load.

Formula Helix's

23 October 2012 - 06:57 PM

Looking for some Formula Helix's.  Looking for 34, 36, 38, 36/32.  Shipping to 12170.

  1. DOOTalk Forums
  2. → Viewing Profile: Topics: MzI
  3. Privacy Policy
  4. Rules ·