Sliders Too Short?
Posted 07 November 2011 - 10:17 PM
They told me they would fit any xp shorty and came already cut...
Here's a picture, too short?
Skids from a 09 600rs
Posted 07 November 2011 - 10:21 PM
Posted 07 November 2011 - 10:27 PM
DJ clutch. (thanx for the input, Joe)
Black tunnel and smooth side panels
Billet wheels, starter handle and gas cap
8-nch rear axle
Cyberdyne coolant temp gauge
exhaust temp gauge
2004 MXZ 600HO Adrenaline
down one tooth on top gear
200/320 primary spring
Cyberdyne water and air temp gauges
Posted 07 November 2011 - 10:40 PM
Posted 08 November 2011 - 02:57 AM
Posted 08 November 2011 - 08:20 AM
Posted 08 November 2011 - 08:23 AM
Posted 08 November 2011 - 09:03 AM
Posted 08 November 2011 - 11:33 AM
The ones I pulled off are about 2" longer. I'll just return them and get ones for a gade
I just replaced the ones on my 09 GSX. I got them from a local dealer and once I had the old ones off, I compared the old and the new and they were the same. With both old and new there was a little bit of the rail sticking out behind the slider - but nowhere near as much as you have. In fact, if you look closely at your picture, you can see a line going across the rail, just in front of the axle. I'd bet you that line is where the old slider left off.
UPDATE: The dealer where I got my sliders has an "OEM Parts Finder" (as many do) and I checked the part number for my 09 GSx and it is 503191301. Just for grins, I looked at the TNT and found that it is the same part number. But yours, along with the other "x" sleds have a different part number: 503190573.
Don't take my word for it, it sure looks to me like yours is different from the regular short tracks. I think if you get the correct part for your sled, they should fit with no cutting.
Posted 08 November 2011 - 12:32 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users