First off i will start with the first pics of my freestyle





Then browsing through my local classifides one day i found a low windsheild bars and a 4.5 in riser for $100



Before i put the riser on i decided to paint it

After one riding season i decited to take off my skis what i found was shocking camoplat injecion molded skis are junk




Decited to add the pilot 5.7s


After looking for knee pads with no sucuss i decited to make a set



At the end of this year my skid plate pulled through the alunium frame

This summer i painted my grills


and i put covers on my cables




Most current pic


thats not it im currently going to put a 6.5" summit riser on ,a aaen silencer and tunnel supports

Looks good Chris, keep it up.

Heck yeah, Chris, you're ready to ride!:righton

Keep us updated with some action pics next, you're probably enjoying snowfall up there by now!

One thing though, could you doo me a favor and turn that one shock cover over the other way? It's bothering me...lol

lol will do action pics will come when we get snow

just picked up a 6in powermadd riser will be putting it on soon as i get my sled back from the dealer

Some great pics of your sled. You'll have snow before I will so I will be living my riding through you at the start of the season. Post lots of pics.

RR

Chris, those cheapy skis are blow-molded, not injection molded. The precision/pilot skis are injection molded and they are solid right through, quality stuff.

oh thanks for correcting me

Hi Chris!

Where did you buy the riser on your Freestyle Backcountry?

Thanks,

Simon Jonsson

bought it off some one who wreked there freestyle got bars riser and windsheild for 100 bucks

so last night i went to put my 6 in riser on ran in to a promblem my riser hiys off my bar clamps due to the way i set it up was going to use my old set up of clamp a bar on to the post then clamp the post on the riser
looks like today i either have to take the riser back and get a different 1 or buy the pivit post adaptor that hack used dont really want to drill out the post tho


the good thing is that there is lots of cable room

finally got my pivit post adapter today. at first i thought it would bolt right on but i ended up drilling it out

bolted together

here it is with my 6in powermadd riser on


tomorrow i have to figger out what to do with the mess of cables even with a 6 3/4 rise there is lots of lenght sill left on the cables





ill just throw this in here to its my home made snowcycle






ill update more tomorrow on the cables and next week will be my silencer install

got everything finished and put together

the cables are a pain to fiqure out the right route

had to sip tie the bar pad on



decided to add the mountian bar


painted my snowcycle will finish it later

got my snowcycle all done





hey hack i switched it around

got my silencer today

out side sound

changed out red for yellow reflectors

im thinking about taking the back rack off and putting a light behind the seat what do you guys think

Go for it. Use the bigger light of the two I got. The small one is hard to see. There is a plug uder the seat near the back on the right side. Remove the seat screw in the plastic (on the outside) to gain access. Leave the plug and cut your wires after that......or get another tail harness to hack up. You may want to put it back on to sell one day.