XP Parts
Rev 440X Parts
Misc Rev Parts
Stock pin weights for Rev 600HO - SOLD
Brand new Rev exhaust bumper (part #514053352) - SOLD
ZX Parts
Full Version: 05' 440X Parts
THREAD CLOSED
XP Parts
BRP 25 tooth top gear (13 wide) - SOLD
09' clear ultra low windshield - SOLD
Rev 440X Parts
440 07' Black centre console (brand new - never installed) - SOLD
440 03' Handguards & mounts 'Batwings' - SOLD
440 05' Jackshaft with bearing - SOLD
440 05' Dash - SOLD
Misc Rev Parts
Rev 800 motor plate with rubber mounts and bolts - SOLD
Rev temperature guage sending unit - SOLD
05' Rev black centre console - SOLD
Eddie's Secondary float kit - SOLD
(2) Rev blue HID xenon bulb (1 tip scuffed)- SOLD
(8) y-pipe bolts with nordlock washers - SOLD
(3) Rev front bumper grills - yellow mesh, black mesh & solid black - SOLD
Rev throttle cable for oil injection (no adjustment nut) - SOLD
Rev upper/lower thermostat housing with T-stat & gasket - SOLD
Rev tail light lense/housing (plug cut off) - SOLD
EPI red secondary spring 205/310 - SOLD
Stock pin weights for Rev 600HO - SOLD
(2) brand new idler bearings (part #6205DU2) for SC3 - SOLD
Brand new Rev exhaust bumper (part #514053352) - SOLD
Rev pull handle support with metal piece - SOLD
(2) brand new/never installed new BR9ECS plugs .031 gap - SOLD
Head bolts (9 left) - SOLD
(8) jug bolts - SOLD
console collar nut - SOLD
5 idler wheel caps - SOLD
ZX Parts
ZX electronic fuel gauge (no sending unit) - SOLD
XP Parts
Rev 440X Parts
Misc Rev Parts
Stock pin weights for Rev 600HO - SOLD
Brand new Rev exhaust bumper (part #514053352) - SOLD
ZX Parts
I there any chance you might have a 121"X15"x1.75" track? 
QUOTE (7073 @ Sep 10 2008, 05:18 PM) 
Check out the 05' 440X parts that I have for sale!
Complete SC4 440 skid
45T slipper gear & 20T top gear
I have a lot of other 440 parts, let me know what you need and I'll take a look - thanks!!
Complete SC4 440 skid
45T slipper gear & 20T top gear
I have a lot of other 440 parts, let me know what you need and I'll take a look - thanks!!
$ for skid shipped to Pictou Nova Scotia B0K- 1R0 Thanks Shawn #902-771-0156
how about the 45t slipper gear and the 440 throttle block? I work in peterborough so pick up wont be a problem
how much do you want for the 440 controls?
Mitch
Mitch
Are you interested in selling the drive shaft without the sprockets.I need a shaft for a different project.If so PM me a price for just the shaft.
if you still have the controls, how much? shipped to saskatoon sask s7h2w3
Is the ZX fuel gauge incluse gauge and sensor for in tank?
QUOTE (7073 @ Sep 28 2008, 08:09 PM)
Updated:
Amber X package windshield is sold
Amber X package windshield is sold
Could you pm me a list of the parts you got left that would fit a 03 rev 800 thanks.
is there a speedometer on the 440x, i have an 05 800x, that the speedo glass is cracked.
if its available, let me know, im in orangeville, i can pick up
gb
if its available, let me know, im in orangeville, i can pick up
gb
do you have a pic of the snow flap? how much for it? and where are you located?
just read that you are from ON. Will you ship to MN?
CHECK YOUR IN BOX
can you post a picture of the fuel gauge?
interested in the solid grille and the 440 console
Where you located?
I'm in Barrie!
I'm in Barrie!
QUOTE (7073 @ Sep 14 2008, 06:07 AM)
05’ 440X Parts
440 slipper gear - 45 tooth (13 wide) - $75
440 Right lower a-arm with spindle - $75
440 07' black centre console - brand new & never installed $60
440 Black centre console (used) - $35
440 Brembo caliper (pads are low) - $25
440 sway bar kit complete - $25
440 Jackshaft with bearing - $25
440 (2) Tie-rods with outside ball joint & boots - $10 each
440 dash (used) - $10
(2) grills for front bumper - one yellow mesh and one solid black - $5 each
Team Secondary belt removal tool - Make offer
Some other misc parts:
Stock 800 ho reed valves with reed spacers - $75
ZX electronic fuel gauge (no sending unit) - $20
Clutch guard with plastic shroud (separated & available if wanted) - $15
Cudney (Red) secondary spring from 600HO clutch kit - $10
(2) tool kit holders with strap (no tools) - $10 each
(8) Nordlock washers for Y-pipe $10 shipped
ZX Hi/Low headlight switch - $5
Complete rev tail light assemblie (121") with wire/plug - SOLD
Rev Tail light housing & lense with wire (plug cut off) - SOLD
Black nose cone (rough but no cracks) - SOLD
BRP 160/320 primary spring - SOLD
440 SC4 idler mounts- SOLD
440 Vented gas cap - SOLD
*Listed prices do not include shipping - paypal welcome*
440 slipper gear - 45 tooth (13 wide) - $75
440 Right lower a-arm with spindle - $75
440 07' black centre console - brand new & never installed $60
440 Black centre console (used) - $35
440 Brembo caliper (pads are low) - $25
440 sway bar kit complete - $25
440 Jackshaft with bearing - $25
440 (2) Tie-rods with outside ball joint & boots - $10 each
440 dash (used) - $10
(2) grills for front bumper - one yellow mesh and one solid black - $5 each
Team Secondary belt removal tool - Make offer
Some other misc parts:
Stock 800 ho reed valves with reed spacers - $75
ZX electronic fuel gauge (no sending unit) - $20
Clutch guard with plastic shroud (separated & available if wanted) - $15
Cudney (Red) secondary spring from 600HO clutch kit - $10
(2) tool kit holders with strap (no tools) - $10 each
(8) Nordlock washers for Y-pipe $10 shipped
ZX Hi/Low headlight switch - $5
*Listed prices do not include shipping - paypal welcome*
just wondering if you still have the clutch cover and if its for a rev
QUOTE (crankshop @ Sep 16 2008, 09:00 AM)
$ for skid shipped to Pictou Nova Scotia B0K- 1R0 Thanks Shawn #902-771-0156
ill buy the slipper gear
QUOTE (7073 @ Dec 17 2008, 10:39 AM)
pm sent
do you still have the snow flap...?
you still have the lower right a arm?
wondering if you still have the sway bar with links and mounting brackets? thanks
any hand guards? pm me if you do
QUOTE (7073 @ Sep 10 2008, 04:18 PM)
Still have some left over parts that I want out of my garage.
Prices and some pics have been added!!
Prices and some pics have been added!!
are the dash and console damaged?
Paul, u busy this weekend? lets go for a boot around your area. u can show me some places where i can possibly wreck my sled. lol then ill need all your spare parts!!!
TTT for ya.
TTT for ya.
QUOTE (7073 @ Jan 30 2009, 07:35 AM)
you wanna go saturday? or if your interested and have someone still learning on sunday i'm doing the family ride with momma bear, but she's picking up the pace pretty good each week so its not that slow. lmk, paul
sunday i made plans with my chick so i dont think i should ditch her to go sledding twice in 1 week.
call me tonight (519) 826-1081 and we'll figure something out for tomorrow. i'm going up to the snocross races in Barrie tonight as a spectator so ill be ready to go saturday to jump some stuff.
love to see the track. is it studded?
I'm looking for a black trunk base for an Adrenaline. I have a 2006 
Thanks for the Reeds and Spacers, and all the parts to install them!
ttt
ttt
Back to life.....
I added a few small things which I have no use for:
- XP ultra low clear windshield
- 05 440 jackshaft
- 05 440 a-arm aluminum bushings
- eddie's secondary float kit
- brand new 400 & 410 main jets
- brand new 20 pilot jets
I added a few small things which I have no use for:
- XP ultra low clear windshield
- 05 440 jackshaft
- 05 440 a-arm aluminum bushings
- eddie's secondary float kit
- brand new 400 & 410 main jets
- brand new 20 pilot jets
i'll take the bulbs, Im in Dundalk Ontario and can meet sometime, PM me
TTT for my boy!!
do you still have the blue bulbs?
10 gallon fuel tank??
PM'd ya.
TTT
TTT
I need a new seat assembly
now that I've sold both sleds and my trailer, i'll be selling everything that I have related to snowmobiling on a fresh thread.
THREAD CLOSED
THREAD CLOSED
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.