Welcome Guest ( Log In | Register )

> 

 
 Reply to this topicStart new topic
> Gravey Davey, Water pump shaft seal replacement
Tree
post Nov 2 2009, 10:16 PM
Post #1


Advanced Member
***

Group: Members
Posts: 118
Joined: 21-March 03
From: Mpls MN
Member No.: 1714
Sled:2008MXZ600X
Thank you for the excellent instructions on post #205419. I tried to reply but something didn't work. I'm better at wrenches than computers. Mine was leaking too bad for a rag but was not contaminating coolant.Heads up, water pump housing gasket no longer available from doo. Also, inner and outer seal are the same part on an 500 SLS any way.Did mine with engine still in sled, I did pull Y pipe off though.
Once again thanks for the excellent post with no BS.
Go to the top of the page
 
+Quote Post
fourcam281
post Nov 2 2009, 10:30 PM
Post #2


Advanced Member
***

Group: Members
Posts: 62
Joined: 7-December 08
Member No.: 61348
Sled:99 MXZ 670 HO
I agree he helped me a lot with this same thing last year.
Go to the top of the page
 
+Quote Post
gravy davey
post Nov 3 2009, 01:22 PM
Post #3


Pigeon River Renegade
***

Group: Members
Posts: 6999
Joined: 18-December 03
From: The Woods Of Northern Lower MI
Member No.: 4239
Sled:2000 MXZ600SB
Glad I could help right_on.gif


--------------------


2000 MXZ600 SB 22/43 gearing Ceramic coated Dyno Port pipe & clutch kit Vforce III reeds
5in ROX articulating riser Boss high rise seat 136x15x1.25 2003 ZX footwells
Shocks by tweener bc3 spring spacers mashaw temp gauge SC10III Simmons Skis

2003 MXZ500 Adrenaline 6.9 Pilot skis Boss high rise seat 3 1/2in Rox articulating riser

2003 REV Sport 600HO 370 mains needles dropped .030 Boondocker beaver delete 2004 seat plastic tail lamp snow flap bumper and cooler Cyberdyne temp gauge Cobra winshield shocks by Monster Performance Snow shooter bushings 6.9 Pilot skis
Go to the top of the page
 
+Quote Post
Tree
post Nov 3 2009, 09:44 PM
Post #4


Advanced Member
***

Group: Members
Posts: 118
Joined: 21-March 03
From: Mpls MN
Member No.: 1714
Sled:2008MXZ600X
Sorry Davey for one last question as I wrap up this project, did you bleed the injector oil?, or just refill. Or ron the pump arm wide open at fast idle? Any imput would be nice.
Think SNOW!
Go to the top of the page
 
+Quote Post
 

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 









RSS Lo-Fi Version Time is now: 21st November 2009 - 04:27 AM
Powered By IP.Board 2.3.6 © 2009  IPS, Inc.
Licensed to: DOOTalk, LLC

  forums  |   mobile forums  |   gallery  |   sponsors  |   store  |   contact us 

All Ski-Doo ~ All The Time
  ©2002 - 2009 DOOTalk, LLC